EED3000B1WW General Electric Dryer - Instructions

removed old knob, cleaned surface under knob, sprayed metal knob on dryer with wd-40, put new knob on. useing the wd-40 makes the knob turn a lot easyer.

Removed old knob, took a pair of needle nose plyers to remove wire band that was left behind from original knob. Slipped on new knob and voila! Easy fix! Now I need to replace rotary start switch.

The gentleman knew what the problem was, sent the right part, and I looked like I was smart.

I was able to take off the front top panel (4 star screws) folded top panel towards me. Marked all the wires to make it easier to remember where they go on new timer. (could have just removed and replaced on new timer as wires were long enough. Pushed old timer down onto panel with screw driver to loosen (this was hardest part) once I was able to loosen and remove the new timer was easy to replace and tighten. Put wires in place. Folding top panel back into place. Closed and tightened screws. Project done!!! Saved about $200.00... GO ME!!!

replaced in same position was previously

All I had to do was snap it on and was ready to go. How easy was that. Would order any other parts again.

It just popped into place :)

Hello,

I just want to start by saying thanks to Partselect for having such a great website. The site is easy to navigate and with the explosion views allowed 'us novice' to select the right part the first time.

With post from previous DIY'ers, help make my repair very easy and simple. I had to replace the timer and the Pulley Idler. I first removed the top, leaving the timer panel connected by wires. I then removed the belt from the drum. That step was easy since the Pulley Idler was broke. I simply slid off the drum with ease. Once the belt was off I disassembled the front panel of the dryer. With the front panel off, I used a 3ft clamp to hold the drum in place while I unscrewed the three drum screws inside. I then pulled the drum out and set to the side. The tension pulley was simple to remove and reinstall. I reversed the steps above until the I got to the installation of the timer panel. With the new timer I put them side by side. I pulled one wire at a time and replaced to the new timer. Once all wires have been transferred, I then pulled the knob off the front. I used a small and medium flat head screwdriver, the small one to pry up the keeper flap and the medium to hold it. I was able to turn the timer and release it with ease. I then inserted the new timer and replaced the knob. I finished reinstalling the dryer and tested. Works great! This all took approximately an hour.

Snapped on new handel. Took all of 5 seconds. The hardest part was finding the part, which your website took care of....Thanks!

Snap on part , order came in quickly and repair done unit good as new. .

remove move 2 screws holding top of dryer down.then remove two top screw holding front panel on so i could get to were my slide bearing where at poped them out and slide in new ones then put it all back together that was it

todd e line eaton ohio usa

I broke the handle

Removed door and two screws to replace the door handle. Reassemnled in reverse order. It was a snap.

This one is so easy my grandson could do it. The removal was easy, it broke off. The installation was a "snap in place". Thinking I needed a few days of dryer use without the handle, I made a temporary repair. I fished some heavy packing string thru the slots in the door, made a loop, than a knot. This gave my wife something easy to grab to open. Did not even need to do the temporary repair, the part arrived in one day.

As soon as the new door handle arrived, I just snapped it into place. It took about two seconds>