64325419 General Electric Dryer - Instructions

My daughter, who has the dryer in Florida, made the repair herself. She removed the broken handle that had been temporarily taped in place. Cleaned off tape residue with Goo-Gone. Then took the new handle and snapped it into place. Worked just like it was supposed to.

I removed 2 screws to remove the top control panel the 5 sheet metal screws to remove the back of panel to expose to timer control switch unpluging the power leads to replace the switch' the repair saved me about $ 400.00. My wife had me looking at replacing the Dryer.

Removed the screws from the back of the control panel. Unplugged the old timer assembly and the timer knob. Plugged in the new timer assembly and put the timer knob on. Put the back panel back on and screwed it back on. Very simple. The dryer now works like new. It has instant heat right away and everytime it used. The selector knob was also installed by just slidding it on. I absolutely love this website...it's save me so much money in having to pay someone else to fix it. :)

Screwed new bulb in socket

Remove the burned out bulb and install the new light bulb.

Just pushed the knob on by hand and it was ready to start! It was great not having the extra expense of a house call! Thank you!

Open the door and removed the part. Installed the new part and started the dryer.

Snap off and then snap New one on.

Wife was out of town, visiting family. I broke the door strike by wedging the dryer door between the laundry room door, closed the laundry room door and it snapped the door strike breaking it. I ordered the part, and it shipped fast using the standard shipping, nothing fancy. Grabbed a pair of pliers and pushed the new door strike into place. It snapped right in, fits and works perfect like nothing ever happened. The wife will never know :)

removed the bulb from the package unscrewed the old bulb & screwed in the new bulb.

removed remaining handle pieces and simply snapped the new part in place. very simple,very easy.

Removed two screws, lifted the top, removed two more screws and tilted the front panel. The worn parts were accessible, and I simply placed the new parts in. It worked. A little trouble placing the top back in the slots, but a fist whack did the job.

Turned off breaker, rmoved back panel, removed timer, replaced knob. Put back together.

First I shut off the gas and unhooked the gas line. Then opened the door and removed the screws that hold the top down in the front. I then tipped the top back so I could get to the top of the drum. I removed the screws ( 4 ) inside the door opening and slid the felt seal back. Next I put the belt in the drum and feed part out the crack between the drum and the dryer frame, being careful not to cut the belt. I woorked the belt around the crack and pulled it toward the drum. When I got the belt through it was all the way around the drum and I just put the belt over the motor pully and pulled the tensioner back and wrapped the belt over it. Put all the screws back in and the back on and fired it up. Works as good as it ever did.

Took apart the dryer housing fairly quickly, pulled out the drum, and installed the kit. Was fairly simple. Then reassembled. The hardest part was trying to get the belt on properly and reconnect to the motor. Believe it or not, I wasted most of my time on the belt. Should've watched the video better and listened to my wife and her suggestions.