DPXR475GW1WW General Electric Dryer - Instructions

At first i tried to repair the old knob before ordering one with tape and glue.kind of a mans thing you know and needless to say that didn't work so for a little while the man thing was we would adjust a crescent wrench to fit the shape of the shaft to set our time on the dryer. i looked all over our home depot stores and lowes here in town and no one carried the part. my wife Angela decided to look on line and see if anyone carried a part like this. thanks to you guys we were able to order the part and it came in and while i was at work my wife called me and said the dryer is fixed. she just fit the new knob on the shaft and it works like new. thank you part select you made my wife happy.

I saw the video and it was just as it was shown!! although there was one gliche....I didn't need pliers!!!It came soooo fast thx PartSelect!!

old dryer knob had lost its spring and would not turn on. simply pulled old knob off and replaced by pushing new knob onto shaft. voila! saved myself a service call.

I didn't have a part number and went online and matched the part to the picture. It came the next day by FedEx and it took less than 5 minutes to replace the old part with the new part. Really simple and easy!

Find the knobs online, order, put knob in place upon arrival.

took off the broken timer knob and put the new one on

Just push the new knob over the metal pin

Remove steel insert and install new knob.

pushed replacement knob on shaft of dryer. machine works better than new. took less than 24 hours from time of order to time of delivery to my house.

Replaced drum bearing part and white slides.The problem was that it was not the drum slide support. It appears to be the the drum rear bearing of whch I am now ordering. The bearing replacement is a little more difficult, but I have taken this on as a challenge

remove front and top cannover's from dryer.remove plastic inside bearing housing and plastic bearing slides replace worn out bearing slides with new ones. needed 4 bearings direction suggested only two....

Faulty Door switch. Dryer would heat up so I knew it wasn't thermostat or element related.

After some research on the internet, I deduced the squeaking sound in our dryer was due to defective drum glides. I ordered a set of four of the white type, knowing only our model requires four glides, but not knowing there are two types for two locations. After disassembling the dryer I realized I needed more parts - two green slides and a new top bearing assembly. The dryer drum had eaten thru glides and into the plastic assembly. That was the reason for the squeaking noise - metal sliding against hard plastic. I ordered the additional parts directly from the manufacturer to ensure I got it right. After all the parts arrived, the repair was easy and took less than 30 minutes. I actually had my 17 year-old daughter do the work to teach her some skills. I just instructed her and stepped in on assembling the top that was just a bit tricky to put back on. Problem fixed.

Dryer would turn on when you pushed the "on" button, but as soon as you let go, it would turn off. Found the plastic door switch cracked (from slamming door closed). Unplugged the dryer. Unscrewed the two screws inside the top of the door to unfasten the top panel. Took the top panel off. Then unscrewed the two screws on the side to unlatch the front panel. Used plyers to take the 3 wires off the switch and slid the switch through the front of the door. Juat remember where the wires go. Then inserted new switch and connected the wires. Vacuumed out the dryer and reassembled. It took about 20 minutes and was easy! If I can do it, you can!!!

1st I suspected it's just the timer knob so I ordered the knob. Soon as I was installing the knob it was too loose, when I inspected the timer stem it was also broke. So I ordered a timer. Soon as the timer arrived, I installed the timer and tested the dryer then it came on.