GTDP280EH3WS General Electric Dryer - Parts

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the...

This thermostat helps to regulate the dryer's internal temperature. L210-30F

This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-r...

This is 39 inches long.

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Note: The drum slides should also be replaced when your replacing the drum bearing. Slides are NOT included. This part helps your dryer operate as quietly as possible.

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

This is a timer knob for your dryer. It is found on the control panel and allows you to turn your dryer on and to adjust the settings. If the timer will not advance, or you notice that the knob is dam...

This part is the replacement high-limit thermostat or safety thermostat for your dryer. The high-limit thermostat is found on the upper right-hand side of the heater housing, and it cuts off power to ...

This is the replacement start push button for your dryer. It is made of gray plastic and is approximately 1 inch in diameter. The push to start button starts the dryer when you press and release it. T...

This fastening nut secures components firmly in place, helping maintain proper alignment and safe operation. It is commonly used as a replacement when original hardware is stripped, lost, or damaged.

This part is connected to the rear bulkhead of the dryer with screws. It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).