CADG265RAL General Electric Dryer - Parts

This rear drum bearing kit is a genuine OEM replacement for your dryer. The kit includes a shaft, ground strap, bracket, bearing and seven screws for installation. The bearing supports that back of th...

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

This part helps to keep the door closed while the machine is running.

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able...

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

Be very careful to not handle the igniter by its gray part. Hold it by its white tip only.

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Also known as Flame Sensor/Detector.

This wheel attaches to the motor.