DPSB519EB0CC General Electric Dryer - Instructions

This is the 2nd time we had to replace the slides. Not a big deal. Removed the top & front of the dyer and replaced the new slides. It's also a good time to vacuum out the inside while you have it apart. Be advised.... Get your tools ready. You'll be receiving your parts quickly. Couldn't believe how fast they arrived!

I opened the unit by removing the two screws over the door, lifting the top (careful not to break the plastic tabs connecting it in the rear to the electronic control panel), then removing the two screws securing the front so I could slide the drum forward and out (hoisting by the belt, bending the sides out slightly). I tested the heating elements for continuity, and tested the two thermostats on the left and right of the heating element for continuity. I found the wiring diagram in the control panel with the specs for the thermistors, which said they should read about 100 kOhm at room temperature. The two on the heating element were OK, but the thermistor on the back of the plastic output box read only about 6 kOhm. After ordering and installing the replacement, it took about 15 minutes to put the drum back in, re-thread the belt, and close the unit back up (thanks to some helpful videos on YouTube). This was the second time this thermistor failed! The first time was under warranty.

I watched the installation video a of couple of times and followed the instructions. Two screws under the dryer door then the top comes off. Then two screws hold the front on come out. Unplugged the two wires to the switch. Removed the duct assembly. Cleaned up the door and snapped in the new duct assembly. Re-installed the door and then the top. Everything was easy - just like in the video.