DWSR485EA2WW General Electric Dryer - Instructions

snap in snap out

Took off the top and front of the dryer---really easy, just two screws for each. Put new drum slides (4) on the front/sides of the drum. Then things got a little bit more difficult. Removed the drum entirely, vaccuumed everything out and had to replace the rear bearings. My husband did this part so I can't tell you exactly how he did it. Not too difficult though. The written directions from here were hard to read---need to make a new copy from the original as it's so copied that it's all smudged. Anyway, once we got the new bearings on, we put everything back together. Dryer works like a charm, at a fraction of the cost it would have been to get someone out to do it. Thanks a bunch for the fast service!

I ordered and replaced the front and rear bearings, including the slides that go on the front bearing. Most of this was un-necessary; replacing the slides would have been sufficient, and much easier to do. Two of the old slides were worn completely away.

I ordered to timer knob. Its was delievered in two days. When I received it, My bother and I looked at it expecting more than what we received, We said to each other this isn't going to work. I told my bother to go on and try it anyway. He took the old timer knob off and then removed a clamp at the base of the timer knob fitting. He then placed the timer knob back of the fitting. Turned the dryer on and it started right up. We were both shocked that it ran and that it was so easy to fix. Thank you PartSelect. Great customer service. I have already ordered a part for his refrigerator! Can't wait till we get the part. I'm sure its going to work just fine.

My husband snapped the new know easily into place.

I was tired of the process after having the know break three times in less than three years which makes me think there is a design flaw.

I matched the flat part of the knob to the dryer part and pushed into place.

Replace the knob with new one

Opened the door and removed 2 screws from inside/top of door. Removed top and then removed 2 screws from back of front panel. Lifted drum slightly to remove front panel and attached new slides.

I took the visegrip pliers off the d shaft and simply slid the new knob on with ease. I never doubted my abilities!

Removed 2 screws from inside door lifted top panel up,removed 1 screw attaching front panel to left side. Pulled front panel out far enough to remove and replace slider bearing.

All I did was stick the knob on. How easy was that! Knob works every time. Very pleased with the part.

I did as the video instruction showed me. I used the pliers and with one pull the metal piece came off and I just put the new knob on it did not take a minute.It was so easy. I am so happy to know that I can get my parts at a great price and do it myself. I have a service plan through my electric company that I pay a fee monthly and if I need services for any appliances there is an additional $25.00 for services and that does not include the part needed to fix my dryer. I ordered my own part with shipping and handling and it still came out less than $25 with no additional fee. I am very satisfied that I now can order parts and do it myself. Thank you PartSelet.

I grabbed the broken knob firmly and pulled it straight off. I took the new knob and pressed it firmly into place.

The old knob broke off & was no longer able to turn the pin to start the dryer. I simply slid the new knob onto the pin & it worked like new.

Took the knob and clip off the dryer and stuck the knew knob on!