DBL333EA1WW General Electric Dryer - Instructions

Turned off breaker, rmoved back panel, removed timer, replaced knob. Put back together.

Just pushed the knob on by hand and it was ready to start! It was great not having the extra expense of a house call! Thank you!

Unplugged dryer and pulled away from wall a sufficient distance to be able to stand behind it. Located the four screws located along to top of the dryer control panel. Selected the correct torx bit (not philips or slot) and unscrewed all 4 screws. Front of control panel rotated open such that the inside of the rotary start switch was visible. Removed broken switch by pushing down the catch tab with one finger and using the other hand to rotate the switch counter-clockwise about 1/4 turn (to the 9 o'clock position). Installed new switch by inserting in the same 9 o'clock position and rotating clockwise until the metal tab locked the stitch in place. Used a vacuum to clean out lint and replaced panel and securing with the 4 screws. Attached the new selector know by lining up with hole and pushing in. Took the extra 2 minutes unscrew the band holding the air vent and vacuum the lint out. Replaced the flexible vent by tightening the band. Carefully pushed back the dryer, ensuring not to kink the flexible vent. Plugged dryer back in. Worked like a champ.

I like to fix , i have time and i just give me the chance to try , and i did it , i wish to pay less for the parts , but was a good feeling when the problem fixed

Removed knob and installed the replacement.

First the old knob was broken just pulled it off. made sure the metal piece was clean of all debris or junk and slide the new know on turned it to make sure it was snug and was ready to go. to easy

There really is not much to explain, the new knob was so simple to replace that my six year old could have done it. No tools were required and it took less than a minute to replace the new knob.

just replaced the old knob

Just pulled off the old knob and pushed the new one onto the switch. Done in 1 minute.

Easy! Just took the broken knob and metal ring off, and put on the new knob. took less that one minute. Works like a charm now. No service call cost either!!

the part fixed all the problems in a cinch

Pull out old, insert new.

I turned off the power, unscrewed the 4 screws from the top of the dryer. I then opened it and turned the switch that was in there counterclockwise exactly as utube video said to do. I then took off the two wires from the old switch. The rotary start switch fix right in where the old one was. I put the panel back together, put on the old knob and turned the power back on! It took less than 15 minutes from start to finish! If I can do it anyone can! Joanne Klinkhammer Cecil, Wisconsin

I just put the new knob where the old one was and presto it was done. The whole process was much easier than I expected.

Yes, we should have done this a long time ago and put off replacing the starter knob and heat adjuster knob. By the time they no longer worked, we called in an expensive repairman. When we realized what the problem was, we thanked him, paid him lots of money and did what we should have all along - replaced the knobs throug partsselect.com instead of using the repairman for another $150.00.

We received the knobs within 3 days (paying for medium fast delivery was worth it) and simply pulled the old problem knobs off and put the other ones on. Simple, no brainer work.

Save yourself expensive repairs and replace those knobs when they start going. Also, when you test the machine, make sure you turn the setting to a time (stupid mistake that most of us do) to make sure that the knobs work properly.

Good luck. A terrific experience with Partselect.com. Would use again in the future and recommend to others.