DCVH660EH0GG General Electric Dryer - Parts

This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-r...

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

This felt attaches to the top bearing.

Note: The insulators on the housing are NOT sold separately.

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able...

This part is the replacement high-limit thermostat or safety thermostat for your dryer. The high-limit thermostat is found on the upper right-hand side of the heater housing, and it cuts off power to ...

This part is located on the housing for the heating element.

This part is connected to the rear bulkhead of the dryer with screws. It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

This part is the replacement lint filter for your dryer. The frame of this line filter is made of white plastic, and is approximately 13 ½ inches wide and 6 inches long. The lint filter sits in your d...

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.