Models > DPSB613GDC > Instructions

DPSB613GDC General Electric Dryer - Instructions

Jump to:

All Instructions for the DPSB613GDC
121 - 135 of 425
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Al from CORP CHRISTI, TX
Parts Used:
WE03X29897
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
BELT SQUEAKING
TOOK OFF TOP AND FRONT PANEL REACHED IN UNDER TUBE AND REMOVED FROM BELT TENSIONER HARDEST PART IS PUTTING BACK ON TENSIONER TAKES TWO HANDS LAYING ON YOUR BELLY
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Clarke from Grapevine, TX
Parts Used:
WE03X37317
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Loud squeek when dryer was running
Take out the two screws holding the top on with the door open remove top and remove two small screws in top front corners. I replaced the 4 slides and the drum bearing without the new felt, do not do this it continued to squeek after it ran the first few times when i got the new felt a week later i installed it in ten minuites and the noise is gone. I think it cost around sixty dollars and my dryer is back in action. Make sure that you clean all of the lint out of the inside of your dryer I had alot of build up near the chute for the lint trap.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ROBERT from MONROE TOWNSHIP, NJ
Parts Used:
WE01X20580
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
door handle broke to dr;yer
handle broke on sunday( not the best day to order things). ordered it from this site and had it by tuesday. great service and best price i found on the web. tks
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Carole from Wynnewood, PA
Parts Used:
WE05X20431
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
light bulb dead
remove the old one and put the new one...!!! Easy
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Doug from INMAN, SC
Parts Used:
WE18X25100
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Old lint filter had deteriorated
Removed old one, inserted new one in slot. Just have to be sure it's turned in the right direction.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeffry from ROCKVILLE, MD
Parts Used:
WE05X20431
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Burnt out bulb
Used a flash light to see, reached in and installed new bulb above the door
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Edward from EDGEWATER, FL
Parts Used:
WE14X25080
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
My last phase of repairs of minor items.
if your unit has over 6,000 hours of operations, one needs to remove the front panel and inspect the sliders that the drum rides on. The video were very helpful to replace the sliders. Unfortunately, my dryer had over 10,000 hours of operations over a 30 years period, hence a major repair costing over $200.00 dollars. The drum sliders were gone, hence the drum eat through the plastic guides. More so, the drum started to eat away the front panel. If the dryer is eating your closes and making a noise, one is looking at a $200.00 repair job. Hence check the sliders early will save one $$$$.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mark from Monroe Township, NJ
Parts Used:
WE05X20431
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Bulb
Open dryer door, reach in at the 12 o'clock postion
on the inside is the bulb.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Peter from LEOMINSTER, MA
Parts Used:
WE05X20431
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Bulb was intermittently working
Inspected door switch operation and was working properly and simply looked for bulb in the dryer drum housing and located it immediately above the door opening,unscrewed it and noticed the broken elements inside. The bulb is a 10w/120V. Installed bulb problem solved.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
victor from ST AUGUSTINE, FL
Parts Used:
WE18X25100
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
door filter
was no repair- removed filter from door and installed new filter into door. No tools required.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dave from EDGEWATER, FL
Parts Used:
WE18X25100
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
take the old dryer lint screen out
Hand replace
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Pete from CEDAR RAPIDS, IA
Parts Used:
WE05X20431
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Bulb burned out
Unscrewed the old bulb using the lefty loosey method. Installed the new bulb by turning it clockwise or righty tighty.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alan from BELFORD, NJ
Parts Used:
WE4M415
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Switch not working.
Open the door and removed the part. Installed the new part and started the dryer.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
KAREN from THIBODAUX, LA
Parts Used:
WE18X25100
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
inherited machine, lint filter missing
Searched the sites order # online, called, ordered, delivered PDQ, unpackaged, popped in. That was it.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
JUDITH from FRUITA, CO
Parts Used:
WE18X25100
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
My lint filter had a big hole in it. My dryer is 10+ years old.
All I had to do was remove the damaged filter and replace it with te new one. It could not ave been easier.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DPSB613GDC
121 - 135 of 425