FEQ221CAS0 Frigidaire Dryer - Instructions

first i had a helper my 9 year old son. we came to this site and read a repair report and we used that to go by.once again my 9year old.

Removed access plate in rear, raised top panel, removed two screws holding front panel (with door) put new belt over drum. Threaded belt through path between motor drive and idler wheel. Put everything back together.

My order was shipped very promptly, and was received very quickly. It is wonderful to have this service available on the internet. I can remember how difficult it used to be chasing down parts before. This was impossible in smaller cities.

Removed the top and front of dryer. Removed the old bearing and held the new bearing in place while my husband tightened the bearing into place......easy......now the dryer runs quiet again.

I pushed the new knob onto the post.

Unhooked wires turned switch to the left put new switch in and turned it to the right 1/4 turn and put knob on front of switch this is the best parts web I have been on so far.

doo handle snapped in place an replced screws that were missing

Vacuumed lint and inserted new filter.

Taking off front of and top of dryer and panels on the back. Releasing the belt and taking out the tube un screwing the two pieces off the back of the machine putting new ones in and putting belt back around drum and setting drum in. Then holding drum while the front is put back on then attach top and a couple panels on the back.

I opened top section with a screwdriver, pushing in the release.
I opened front panel with door with screwdriver pushing in the release.
I lifted drum out through the front.
I replace the Idler Arm assembly.
I greased the rear drum bearing race.
I vacuumed out and cleaned blower and dryer area.
I put the new belt on the drum, reinstalled the drum.
I put belt around drive motor and Idler arm assembley.
I put front panel with door back on.
I put the top panel back down and snapped into place.
Tested dryer, job done!

You simply pry the old handle off with a flathead screwdriver, and then line up the new handle and snap it into place. It took less than 30 seconds! A breeze.

Pulled front off dryer, popped the top up, took belt off pulley, pulled drum up and out just far enough to pull element out and put new one in. Very easy and quick. PartSelect always sends good quality parts and very quickly. I will use them for all my repairs.

just like the excellent video showed me. It was so easy and the web sight has a video to show me how to do it. Piece of cake! Thanks so much.

unscrewed the back panel using the diagram provided on the website and easily removed and replaced the parts with the help of the supplied video tutoring.

I replaced it...just popped it in.

Very simple just put the new ones on to replace the old knobs that broke. Thanks for the quickness of getting our parts to us. So nice to not have to use a tool to turn the dryer on. Very happy with the pricing and quickness it was delivered to us.