All Installation Instructions for Frigidaire Dryer FGR221CAS0

Customer:: MANUEL from SAN JACINTO, CA
Parts Used:: 134503600
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

drum belt

so easy my daughter installed it the video was very helpful

Was this instruction helpful to you?

Customer:: Mike from Goldonna, LA
Parts Used:: 131825900
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

dryer was making a shrill noise

removed the front then removed the belt that turns the drum pulled the drum strait up from the top then removed the bushing from the back wall put the new one in I also put A little grease in the new bushing to keep it from wearing installed the drum and front. realy easy. I'm A Instructor at A technical collage in Winnfield Louisiana and I used this as A project for my students.

Was this instruction helpful to you?

Customer:: Jeffery from Auburn, NY
Parts Used:: 134011703
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins

timer knob broke off

did exactly like the video in five minutes dryer up n working nice way to go love the site

Was this instruction helpful to you?

Customer:: Brad from Lakeland, FL
Parts Used:: 134503600
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

Heating Element Failed!

I youtube'd the repair, and repaired it! While I was at it I replaced the belt! (Highly recommend replacing the belt while you are replacing the element!) Was a snap!

Was this instruction helpful to you?

Customer:: Brian from LOXAHATCHEE, FL
Parts Used:: 134503600
Difficulty Level:: A Bit Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Screw drivers

Belt & drum bearing

Had the drum bearing but had never got a round to putting it in we just let it squeek. Then the belt went. Easy enough, whatched the tutorial once and just did it. 35 minutes and back drying.

Was this instruction helpful to you?

Customer:: Benny from Long lake, MI
Parts Used:: 134503600
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

broken belt

it was so easy using the video that you emailed me. I want to rebuild my whole drier now .

Was this instruction helpful to you?

Customer:: Kisha from Jacksonville, FL
Parts Used:: 134011703
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Timer Knob broke

Just slid the new timer knob on the dryer and we were all set. Super Fast shipping and easy to replace. Thanks so much!

Was this instruction helpful to you?

Customer:: Richard from New Orleans, LA
Parts Used:: 134503600
Difficulty Level:: A Bit Difficult
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Heating but drum not turning

With drum not turning, I removed rear access panel and confirmed that the belt was missing from the motor pulley. The instructional video provided by PS was extremely helpful. It made the job simple. Removal of drum thru front frame was the most difficult part which was relatively easy. Once the front panel and drum were removed, I could then see that the front drum top glide nylon/felt strip needed replacing which I then obtained.

Was this instruction helpful to you?

Customer:: Paula from Tryon, NC
Parts Used:: 134503600
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

drum would not turn

Opened top and screwed the front off. Put belt around drum. It took two times as my sweet husband put the belt on backwards the first time.

Was this instruction helpful to you?

Customer:: Jon from Jenkins, KY
Parts Used:: 131825900
Difficulty Level:: A Bit Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

needed to replace drum bearing

took front panel off, removed access panel in rear to disconnect the belt from motor. removed top panel (this is a stack unit) take plastic rivets loose from lint trap, remove lint trap tube, pull drum out after slightly pulling up to dislodge drum from bearing cradle, Remove bracket and bearing from back of unit, clean parts of old grease (be carefull not to loose small ball bearing on back) Reassemble parts using moderate amount of new grease, put parts back together in reverse order.

Was this instruction helpful to you?

Customer:: John from Minot, ND
Parts Used:: 134503600
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Pliers, Screw drivers

Broken belt

Remove drum, replace belt, return drum

Was this instruction helpful to you?

Customer:: Edwin from Brooklyn, NY
Parts Used:: 5303931775
Difficulty Level:: A Bit Difficult
Total Repair Time:: 1- 2 hours
Tools:: Screw drivers

no heat

Remove top cover 2 screws then remove front panel 6 screws remove wire connecter on the door panel. ignition coil is on the bottom left side need a short hand srew driver remove 2 screws remove plate holding coils remove coils and connecter. Reinstall in reverse installation. Dryer still didnt heat up so back to the drawing board :)

Was this instruction helpful to you?

Customer:: Edward from Sayville, NY
Parts Used:: 134503600
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins

Broken belt; Second one in 2-years.

I heard the dryer running, but I didn't hear it tumbling like usual, so I got suspicious. I popped the top off of the dryer to reveal a broken belt. Installation took 20 minutes.

Was this instruction helpful to you?

Customer:: gary from little torch key, FL
Parts Used:: 134503600
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Cut belt

I followed the vidio from yor web site it was great without it i would still be trying to get done.

Was this instruction helpful to you?

Customer:: Kama from Athens, WV
Parts Used:: 134011703
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Timer knob broke

I just put the new knob on. Took 2 seconds. Works great.

Was this instruction helpful to you?

FGR221CAS0 Frigidaire Dryer - Instructions