Models > FER341ZAS1 > Instructions

FER341ZAS1 Frigidaire Dryer - Instructions

Jump to:

All Instructions for the FER341ZAS1
76 - 90 of 270
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Linda from COVINGTON, KY
Parts Used:
131863007, 134503600
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers
Could not do as video.
Had to open back side vent & use needle nose to secure spring.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Randall from Mount Horeb, WI
Parts Used:
134844410
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Start Knob Broke
My wife simply removed the knob from the package and pushed it on. No tools were needed and she felt satisfaction that she was able to "fix" the problem on her own.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Myrna from Apache Junction, AZ
Parts Used:
134398300
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
The start switch was broken
Took the front off the dryer and removed the old switch and put in the new one.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Allan D from REDLANDS, CA
Parts Used:
137551901
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
the attached anchors and holes linled up about 80% of the time.
I cut off the four that didn't line up - I suppose since this was a gasket that fit several makes, I should expect this type of problem.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
CLARK from JUNEAU, AK
Parts Used:
134886700
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
broken knob
removed knob..very easy instructions..took 10 min...very pleased with repair and fast order...
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from Yucca Valley, CA
Parts Used:
134398500
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Broken switch
Removed rear cover, unplug 2 spade connectors, twist out old switch, twistin new switch. plug connectors, install cover
4 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cynthia from BUFFALO, NY
Parts Used:
134398300
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Dryer start knob broke clean off
I YouTube'd how to repair it. It was super easy. Needed a power drill to get the screwsa off and a flat head screwdriver to pry off the wires but besides that it took about ten minutes and I was finished.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
melissa from west chicago, IL
Parts Used:
134844410
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
plastic start knob stem broke off
First I unscrewed the back panel to be able to lift the cover off the control panel. I then removed the cover off the control panel and slid the knob into the locking tabs. I replaced the cover and screwed the back panel back into place.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Susan from FULLERTON, CA
Parts Used:
131644700
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Broken door handle
I unscrewed the 2 screws on the side of the door and the 2 screws on the bottom of the door, removed the broken handle and r replaced it with the new one.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donna from BAKERSFIELD, CA
Parts Used:
131644700
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
door handle on washer broke.
Took out of package. Used screw driver to pop off old broken handle.
Installed new part in a minute or two. Nothing to it. Was very pleased to get the part and so easy to install.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from CUMMING, GA
Parts Used:
134222900
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Top hinge on clothes dryer separated, leaving door difficult to open/close
Ordered part from partselect.com. Part was back ordered; however they were very proactive in communicating status updates! When it arrived it was simply a matter of removing door using a philips screwdriver, installing the new hinge and presto - job complete! Kudos to partselect.com ??
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Anne from SANTA BARBARA, CA
Parts Used:
131644700
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Plastic door handle for dryer needed to be replaced.
Snapped the new door handle replacement from this site in place. Fits perfectly.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Doug from TROUTDALE, OR
Parts Used:
131644700
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Dryer door handle broken
I just used a putty knife to remove the broken one. It just popped right off.
The new one just popped into place.

I want to say that the girl / lady that answer the phone was extremely helpful and very professional,.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Philip from HAYESVILLE, NC
Parts Used:
134844410
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
broken selector knob
Simply pressed knob on appliance.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Judy from SAN DIEGO, CA
Parts Used:
137551901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
prolonged drying period and poor lint collection
removed the old gasket with pliers (noting where the beginning/end of the gasket was) then installed new gasket in the exact location with very light pressure on each rubber insert point. Voila!!
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FER341ZAS1
76 - 90 of 270