FER231CAS0 Frigidaire Dryer - Instructions

Found part through Google, ordered part and received it in three days. Easy as pie

pulled old one off lined up new knob pushed on new one no tools-- less than a minute..

took off the old one,and the inner sleeve and put on the new one.

After pulling up the Frigidaire site on internet, there was a video as to how to replace the knob. Very simple to replace. Ordered it and the turn-around time was very fast.

When the Time Knob broke, I planed to buy a new dryer. My friend told me of this site. I cheched the site and made the order, less than 36 hours, I received the part, less than 1 minute. I replace the knob and it bakc to work. It costs me only $15.

How I love this site!

I was surprised that the knob actually broke, and was also surprised at how much the part would cost direct from the manufacturer. The website had a ton of different knobs available, and I'm sure a number of them would have fit. The part showed up in just a few days and fit perfectly. Trying to set the dryer time using pliers makes a person appreciate the proper parts!

Repair was simple and easy. I thought I was going to have to get a new machine.

Thanks

First, I took the new knob out. I slipped it easy on the washing machine.

It was all done.

I am very impressed with Part Select. My part arrived the next day without paying the extra shipping and my husband put the new knob on less than 30 secs.

Just replaced old knob.
Service was great. Ordered knob on Sunday and received new one on Tuesday,

Removed top and front of dryer and rear panel. Installed belt and new idler pulley. Reinstalled top and front panel and rear panel. Dryer worked great.

I simply had to open the plastic and stick the new timer knob on the dryer. It fit perfectly and more importantly, it arrived within 48 hours of me placing my order. Thanks!

first i had a helper my 9 year old son. we came to this site and read a repair report and we used that to go by.once again my 9year old.

Removed access plate in rear, raised top panel, removed two screws holding front panel (with door) put new belt over drum. Threaded belt through path between motor drive and idler wheel. Put everything back together.

My order was shipped very promptly, and was received very quickly. It is wonderful to have this service available on the internet. I can remember how difficult it used to be chasing down parts before. This was impossible in smaller cities.

I love technology. First thing I did was google on "U-tube", "How to repair a squeaking dryer". Several videos out there so I just found the one I needed and watched. The repair itself went easy. A word of advice would be to be careful of sharp edges and to remember to unplug the machine prior to repair. While the drum is out, go ahead and get your shop vac and clean the inside of the unit out. Also, not only put grease on the new plastic holder, but put some on the shaft of the idler puller. I also used an awl to line up the holes on the front panel when re-installing the screws. One video I watched showed reaching in through the front to take the drum belt off the pulley, where another showed removing the inspection plate on the back. This made it much easier.

Removed obvious screws to the vent etc. Then had a little trouble getting the cabinet open. My only problem was getting the front top panel off. A clip about 2" from either side at the top needs to be pushed in with a flat head screwdriver to release the top. Other than that the task was pretty straight forward. Two sets of wires to the heater itself. Used pliers to help pull them loose.