DGDMW3 Frigidaire Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gary from Oviedo, FL
- Parts Used:
- 5303937186
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers, Wrench (Adjustable)
gas dryer starts but no heat
after checking on line, i shut off the gas and disconnected the burner unit from dryer. after removing unit i tested all electronic parts and found the igniter was bad. i removed same and ordered new part. when new part was delv. i reinstalled the unit and all worked like new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Manila, UT
- Parts Used:
- 5303937186
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Wrench (Adjustable)
No Heat In The Dryer At Our Summer Cabin In Manila Utah
There was no heat, the dryer worked in all respects but the flame did not come on to dry the clothes. I suspected the ignighter so I disconected the wire leading to the ignighter and tested the electrical connection with a regular tester used for testing 120 v ac circuits in a normal residential house outlet. I turned the dryer on and used the tester on the incoming electrical line that I disconnected from the ignighter there was power so I determined that the trouble was with the ignighter,it took about ten minutes to replace the ignighter after I received the part from partselect. The dryer worked fine with the new part. A fairly simple job to take the burner out and install the ignighter.
Was this instruction helpful to you?
Thank you for voting!