NEC3240FW0 Amana Dryer - Instructions

Lifted top of dryer using putty knife. Took front panel off using socket wrench. Slipped drum belt off an took drum out. Vacuumed out entire interior. Replaced rollers an clips and reassembled!! Saved $100!!! Thank you!!

Simply installed the piece and I was done. Took 10 seconds.

Popped out the old door catch kit and replaced it with the new one! Easy!!

Simply put it in the exhaust hole.

My dryer knobs ended up not only the problem but when i went to use my dryer the heating element wrnt out.... So i need to return your knobs and get my money back please thankyou however i need the correct forms to send them back and i have the original wrapping

All I had to do was get the model number off of the dryer and plug that information in online and within a couple of days the part arrived. It was great! There were directions that came with the part that explained how to replace the old latch with the new one.

I remember in the "olden days" when I would of had to call a repair guy out and paid a lot more than the $12.00 I did to replace the part myself. And, the only reason it was $12.00 dollars instead of $5-6 was because I had it shipped overnight.

Awesome!

Take out the two screws the hold the lint screen filter compartment in place. Remove the two top clip retaining screws, and lift the top LOOSE and turn it a bit out of the way. I didn't find it necessary to remove the top. Unclip the two wire electrical connector at the top - front, and remove the 1/4 " screws the secure the front. Lift the front up and out of the way. Slide the drum belt off the tensioner and moter pulley and slide the drum out the front. Remove and install the rollers ( and its just that quick) and while your in there. Clean up a bit ... cant hurt right? Especially on and around the motor. Reverse the procedure but rotate the drum a few turns to properly position the belt. Total E.T. is maybe 20 minutes and on a 1 - 10 scale for "degree of difficulty ". This is about a 2. Save the money and do it yourself.

The repair was simple as you can imagine. Thought I could buy these legs at any big box store or at least at the local hardware store. No such luck. Partselect had the right product---easy to order and easy to install. Things around here are great.

Top up, front off. Drew a picture of how the belt was positioned. Removed the belt and drum. Removed a heat plate to access the lower wheel. Replaced it and then replaced the upper right wheel. Was a little concerned the white triangular washers would break going on to the shafts but it turned out there much stronger that I thought. Cleaned out the bottom and found a lot of coins. Put it back together and now it sounds like a new dryer. Use gloves, some parts inside are very sharp.

Took of the old roller and replaced it.

Completly gutted every part of the machine, to put in the drum support rollers. Really wasn't that difficult. But you will need 2 people. One needs to hold the drum while one replaces the drum roller.

Took off the out cover of the dryer unit. Removed the drum. Then replaced the roller

watched repair video and fixed dryer.

The first and best thing I did was watch the instructional video. This was very helpful. I removed the lint trap and two screws, then pried the top off using a putty knife as described in the video. I I disconnected the wiring harness and the two screws holding the front panel, then removed the panel. Next, I removed the belt from the drum and removed the drum. I had a little difficulty removing the clips holding the rollers, but was able to pry them off after a few minutes. I installed the new rollers and reassembled everything. Note: I used the nut driver to push the new clips onto the roller pins. The problem was resolved and the dryer is working fine!

popped open top, removed two springs on lower end of front panel.took off same panel, pulled drum forward, pulled jesus clips from roller pins ,took off old rollers and replaced with new rollers and clips.