NG6819 Amana Dryer - Parts

This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Sold Individually.

The bracket is no longer included.

This screw is sold individually.

At just two and a half inches, this metal spring fits onto the arm of the idler pulley assembly of gas and electric clothes dryers.

Part may differ in appearance, but functions same as original.

This single drum support roller is used for round ported model clothes dryers. It is three inches in diameter. The outer black ring of this support roller is made of rubber. While the middle white par...

This clamp is used to secure the drive motor.

This screw is sold individually.

This thermostat helps to regulate the dryer's internal temperature.