DV306LEW Amana Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Angelique from Greensboro, NC
- Parts Used:
- WPW10222771
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable)
heat stoped working
The repair was pretty easy to install the heat element, but had to replace several other parts do to the manufacturer that had broke off
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Beatriz from Sharonville, OH
- Parts Used:
- WP35001193, WP35001191
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
the thermistor was open circuit
I change the Thermistor 3 bracket and worked well for 10 minutes and the thermistor is broken again
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joe from West Palm Beach, FL
- Parts Used:
- WP35001193
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Dryer turns on no heat
Test thermal fuse for resistance. If has 0 resistance you have a bad fuse. Also check voltage going to wall outlet. Must use at least 600 volt tester. Motor will run on 110 volts, but will not activate heating element. Heating element must have 240 volts to operate. Always make sure you turn off power when working on electrical problems. Be safe and good luck.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bobby from Amory, MS
- Parts Used:
- WP35001193
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Would not heat
Took the top back screws off (2) then pulled the top toward me and it came off. This left four screws that hold on the front control panel. I took out this four screws, which the control panel came out. You will then have to disconnect the door switch. Then I took off the front door, which which has two screws. Then I took the four screws out of the front panel,which are all on the top below the front control panel. You then have to pull up on the front panel to lift it up, it is sitting on two slots. This will give you excess to the heater. There will be one screw take it out and the heater will pull out also there will be six wires that you will have to disconnect so pay attention where they go (write it down.) You will have thermostat 2 and 3 and heater switch. Test them with a ohmmeter, my thermostat 3 was bad. There will be two screws to take out to replace the part. Put the wires back and put the dryer back together like you took it apart.
Was this instruction helpful to you?
Thank you for voting!