LEA80AL-PLEA80AL Amana Dryer - Parts

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This orange dot heating element replaces those elements with an orange dot on the element flange. It carries 240 volts.

This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.

These brackets support each side of the tub. Order quantity needed.

This 1/4 horsepower gas or electric clothes dryer motor carries 120 volts, 60 Hz, and 5.5 amps. It also performs 1725 revolutions per minute. This motor is used for some gas and some electric clothes dryers.

Part may differ in appearance, but functions same as original part.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This part includes the upper and lower air duct assembly and lint screen.

This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.

This arm is what attaches to the idler pulley wheel.

This cycling thermostat has a limit of 153 degrees Fahrenheit, meaning that your dryer will cut out when the internal temperature reaches 153 degrees. It kicks back in though, when the temperature dro...

Sold Individually.