Models > AGD4370TQ0 > Parts

AGD4370TQ0 Admiral Dryer - Parts

Jump to:

1 - 12 of 132
Keep searches simple, eg. "belt" or "pump".
This multi rib belt is an OEM replacement part for a dryer. It attaches to the drum, idler pulley, and motor pulley, and is responsible for spinning the drum. Over time, the belt can become frayed, br...
In Stock
Order within the next 7 hrs and your part ships today!
This thermostat is an OEM replacement part for a dryer. It is sold individually. It measures approximately 2-inches by 1.5-inches, is black and silver, and constructed of plastic and metal material. Y...
In Stock
Order within the next 7 hrs and your part ships today!
This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both h...
In Stock
Order within the next 7 hrs and your part ships today!
This is a genuine OEM replacement igniter kit for your gas-heated clothes dryer. The silicon carbide igniter is used to light the gas that creates the heat in order to dry your clothes. If your dryer ...
In Stock
Order within the next 7 hrs and your part ships today!
This small but mighty OEM piece is called a tri-ring and is used to support the drum roller shaft and the idler pulley shaft in your dryer. It helps to provide a tight seal between components by evenl...
In Stock
Order within the next 7 hrs and your part ships today!
It is important for your dryer to be properly leveled, as an unleveled one can cause excessive vibration and noise when operating, may not drain properly, and can cause excessive wear on various parts...
In Stock
Order within the next 7 hrs and your part ships today!
This genuine OEM part is a radiant flame sensor for your gas dryer. It is used to determine when the temperature of the igniter is hot enough to ignite the gas. Once the igniter is hot enough, it allo...
In Stock
Order within the next 7 hrs and your part ships today!
This kit comes in two pieces: the catch and the clip.
In Stock
Order within the next 7 hrs and your part ships today!
This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.
In Stock
Order within the next 7 hrs and your part ships today!
The push-to-start switch is a genuine OEM part for your dryer. When the button is pressed and released, it activates the dry cycle for your laundry. If your dryer will not start or it shuts off too so...
In Stock
Order within the next 7 hrs and your part ships today!
A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.
In Stock
Order within the next 7 hrs and your part ships today!
This OEM high-limit thermostat kit includes the thermal cut-off fuse and the high-limit thermostat. The purpose of this part is to cut-off power to the dryer when it overheats. Common indications that...
In Stock
Order within the next 7 hrs and your part ships today!
1 - 12 of 132