DU7500XR0 Whirlpool Dishwasher - Instructions

The brackets that held the original wheels were still on the rack. They were easily pulled off the rack. The new assembly did not look like the original part. It was not difficult to see how they fit onto the rack. The only caution is to press the top part of the new assembly onto the frame before snapping the rest of the new piece into place.

I looked online to see a video. Dad to pop lid off soap dispenser. Slide a plastic part to the left n the spring slide off. Video showed how to place prongs on spring . Then had to lift the upper part of spring to lift onto plastic part of soap dispenser. That was it.

Unfortunately it still doesn't work. I asked Ina email to your company for any suggestions, No reply.

After removing the lower front kick panel, I replaced the door springs without taking the dishwasher from the cabinets. This job took 20 minutes from start to finish. Very easy with the directions supplied.

All pieces just snap off and the new one just snap right back in place.

Remeber take a little time to do your repair correctly.

It is cheaper to repair an appliance than it is to replace.

Simply snapped out the old ones and snapped in the new ones. Worked like a charm. Glad you had the parts.

Swapped out the old upper dish rack with a new one. A video made the change simple.

the plastic pin that retains the spring has a head on one end that hits a plastic stop on the door to keep it from coming out. I used a small grinder and made a flat spot on the head diameter to make it easy to slide out. This is easier than trying to pry the door off the pin at the two retaing snaps. I was conderned these pin retainer clips were brittle and would break off.
Once the pin is slid out, it is a matter to hold the new spring holes in line with the pin. rotate pin so flat side you ground is turned up, so pin will not move out that way. Tiij about an hour

watched a video

Looked at existing assembly and snapped on new one, duplicating existing installation.

Snapped in new part

This problem was making me NUTS! Every time I pulled the lower rack out, the rack would go off the track, threatening to break every dish, and I would literally have to half-carry the rack to move it in and out. VERY frustrating. No money for a new dishwasher, didn't want to pay for a whole new lower rack ($100). Then I discovered I could simply replace the wheel assemblies for less than $30 and no toold required. Yee-hah! It was literally a SNAP!

The rack came with pictorial instructions which were fairly veg, however they were to the point. The wheels snapped into place easily, and the center water transfer tube twisted off the old one and twisted on the new one just fine. It is a very good idea to keep the old one out to look at as a guide. There were no instructions on how to remove the transfer tube, I was lucky to have already worked on these before. After that it fits and works just peachy.

Piece of cake. Unsnapped the old parts, studied the new ones for a minute to orient myself, and snapped them on. Not quite as simple a twist as the old ones took, but no problem once they were lined up properly. Total time, about 5 minutes or less.

pulled old wheel housing off and replaced with new replacements ones. Straightforward task.

real easy to install. i took off all 4 sets of rollers. i installed the first set improperly and the 2nd,3rd and 4th properly. i then went back and refasten the first one. no tools needed. 15 min.