DU8100XT3 Whirlpool Dishwasher - Parts

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This gray upper dishrack kit fits select dishwashers. It requires assembly, and non-adjustable models may need roller transfer. The updated design may differ slightly but functions the same.

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

16ml

This clamp helps to prevent leaking by holding the end of water hose in place.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

This spray arm is just underneath your upper rack.

This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be loca...

This part goes at the end of the rail to stop the dishrack from falling out.