MDB6657AWQ Maytag Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Karin from Tempe, AZ
- Parts Used:
- WP99002135
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Guide rail broke
Snapped in the new part!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Houston, TX
- Parts Used:
- WP99002073, WP99002072
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Right side roller of upper basket kept coming off track because one of the 2 wheels was broken which came with the replacement strip. The plate was also broken and replaced to hold the strip in place. Easy fix.
Simply took old parts off and replaced them with new parts - no tools required.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joyce from Fort Myers, FL
- Parts Used:
- WP6-918873
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Old basket seperated on the bottom.
Removed the handle from the old basket and put it onto the new basket. The new basket is great!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kris from Mohrsville, PA
- Parts Used:
- WP99001443, 99001426
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the cap sprayer fell off and melted during a cycle
I placed the distributer cap on and tightened with the housing nut and snapped the cap on and it was fixed. Very easy, no tools involved.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from MILPITAS, CA
- Parts Used:
- WPW10116811
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
upper spray arm won't stay attached to dishwasher ceiling
remove damaged retainer clip. Install new one. Note: the upper spray arm screws onto the ceiling of the dishwasher with a reverse thread. That is, you need to turn it counter-clockwise to tighten it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Doris from CONCORD, NC
- Parts Used:
- WP99001443
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The spray diverter assembly came off and was locater under the rack next to the heating element - heat melted the plastic diverter and lid
My nephew actually put the new part back on for me. The main problem I had was getting both parts of the diverter ordered at the same time. I had to order the lid after the diverter came in the mail! I did not realize it was a two-part replacement piece. I learned later that the lid was a separate part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Pompton Plains, NJ
- Parts Used:
- WP99002069
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Stinky dishwasher
When I tried to remove the hold down screw for the impellar, the impellar broke in half. I actually did npt need to go this far with disassembly as the problem was with water being retained in the rinse arm assembly and stagnating. This was due to calcium buildup clogging the drain holes. Clearing the holes resolved the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from MILFORD, CT
- Parts Used:
- WP99002106, WP903093
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
The upper tray came crashing down on top of the lower tray because a couple of wheels let go over time.
I ordered the parts after looking at the diagrams. I ordered a total of 5 pieces.
The parts arrive earlier than expected, and were new, OEM, parts. I cannot stress how important it is to order Original Equipment Manufacturer parts.
I replaced the broken pieces within 30 minutes. Great experience.
The parts arrive earlier than expected, and were new, OEM, parts. I cannot stress how important it is to order Original Equipment Manufacturer parts.
I replaced the broken pieces within 30 minutes. Great experience.
Was this instruction helpful to you?
Thank you for voting!
Door springs dissconnected broken links
Removed 2 each screws from counter top. Pulled washer out 1'. Installed springs and linkage by hand with door closed. Push washer back reinstalled 2 screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from BETTERTON, MD
- Parts Used:
- WP912653
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
door spring linkage, a plastic part, broke so the door spring didn't hold the door upright.
Took off the lower front plastic piece and unscrewed the side panel to snap the new part in place then attached the spring to it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from WENONAH, NJ
- Parts Used:
- 99001454
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Upper dishrack had rust and corrosion Several upright tines were broken off/
Just slide the old upper dishrack forward to the end. The stops on either slide must be removed . Only difficulty was getting the plastic stops to open up. We used a thin metal knivre to wedge into the opening.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from MARBLEHEAD, MA
- Parts Used:
- WP6-918873
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Some of bottom wire in the silverware basket had rusted out allowing silverware to fall through and interfere with rotating arm.
The "repair" was actually a replacement. My wife did it. She took out the old, damaged basket and dropped in the new, replacement basket. She removed the slotted lids because she doesn't think they are necessary and she doesn't like them. I got the old basket for holding small items in my workshop. The lids will be thrown away, unless I can come up with a use for them.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barb from TWINSBURG, OH
- Parts Used:
- WP6-918873
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The silverware basket needed replacement since there were cuts in some places on the bottom which caused utensils to fall partway through.
Very simple. Just replaced the old one with the new one. Voila!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Groff from WVisconsi Rapids, WI
- Parts Used:
- WP6-918873
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The bottom of the old basket was breaking and silverware was getting stuck
Open the door and remove old basket. Place the new basket in its plave. Time elapse approximately 20 seconds
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeff from BURLINGTON, WI
- Parts Used:
- WP903093
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Wheel axle had broke and the wheel was not connected.
Actually following the online video is the way to go.
Was this instruction helpful to you?
Thank you for voting!