DU2J3B Magic Chef Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Both door springs corroded and broke. Linkage connectors broke also.
After pulling dishwasher out both springs easily installed using plastic connectors on the bottom left and right sides. Pliars were used to stretch the springs. It took fifteen minutes at most.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bernice from New Vernon, NJ
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Leaks onto floor from lower section
First I replaced the door gasket as every one else. This cut drips about 30%. I then discoverd that the Rinse Aid circular dispenser cap was opened about half way. I turned the cap tightly clockwise to close and cut drips to 90% total. I czn live with the other 10%,
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bernadette from Glen Cove, NY
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
leak at bottom left and right side
pulled out the old gasket, cleaned the area before pressing in the new gasket with my fingers ,I made sure to put it in the same way as the old one. You have no idea how happy I am that this solved the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ernest from Santa Ana, CA
- Parts Used:
- WP99001553
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Soapy water leaking from bottom of dishwasher door
The dishwasher was running perfectly, but over time it leaked more and more. We were ready to throw it out, when I searched the internet and saw stories about a tiny gasket commonly failing. I couldn't believe that could be the trouble, but ordered the $3.75 part. Unscrewed the door, slipped out the old gasket and slipped on the new one. Screwed the door back. And the result? THE LEAK IS FIXED! Unbelievable. The old gasket had gotten stiff, probably exposure to soap, and it wasn't sealing properly. That $3.75 part saved us hundreds and hundreds of dollars and will give us extra years of use from our dishwasher.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Raymond G. from Whittier, CA
- Parts Used:
- 99002254
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Dishwasher wouldn't start, no power on any setting
Removed door interior, confirmed with tester that power was reaching door cut-off switch, but not power on other side of switch when engaged. Noticed that little switch button frozen in shut position, assumed switch had burned out. Installer new door cut-off switch with new (dual) switch units in place, plugged in unit and it ran perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from Whitinsville, MA
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Leaky door
Removed old gasket and simply replaced it with the new one. Very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- joseph from goffstown, NH
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
washing machine leaked at right lower corner
removed old deteriorated gasket - just pulled out
cleaned soap particles from door seal area
pressd in new gasket - note orientation
done.
still leaks - will investigate further
cleaned soap particles from door seal area
pressd in new gasket - note orientation
done.
still leaks - will investigate further
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marc from GLENDALE, NY
- Parts Used:
- WP99002560
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
After 22 years of virtually trouble -free service, I could tell by the sound that something was wrong. Water fill ran too long. Float not stuck. Checked and found float switch stuck.
Very simple. Remove bottom panels. Remove one screw holding old switch in place. Move wire connections from old switch to new one. Cleaned and lubed the switch actuator. Mounted new switch. Checked that float and actuator worked freely. Left bottom panels off till I ran a load - just to be sure all was OK. Remount bottom panels...Done! P.S. Don't forget to turn power off to dishwasher any time you work on it!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Teresa from Terre Haute, IN
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
My dishwasher was leaking from the bottom right hand corner.
I removed the original gasket, wiped down the area, and installed the new gasket the same way the old one was installed. It was very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stacy from DEPEW, NY
- Parts Used:
- 99002254
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Dishwasher would not start/run
Followed the instruction video provided by this site ! 15 minute repair?..Super Simple!!! I Love this company!!! Saved me a bunc of money!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elizabeth from CHEEKTOWAGA, NY
- Parts Used:
- WP902894
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
When I would run my dishwasher, water would pool on the right side front of the washer. It was even dripping down into the basement. When I figured out it might be the the front door gasket, I ordered the part.
The repair was very easy! I simply pulled out the old gasket from around the front part of the dishwasher. I cleaned the area with a damp rag from any residue that was left on. I bent the long gasket in half and and pushed it in starting at the center of the dishwasher and went down one side at a time until the whole gasket was in. I then ran a short cycle on the dishwasher to make sure it was properly in place and the problem was fixed. NO MORE WATER ON THE FLOOR! I was so very happy to know my problem was fixed and I didn't need to buy a new dishwasher! It's been running great! :) ~ Elizabeth ~
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Chris from SPRINGFIELD, VA
- Parts Used:
- WPW10117748
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Dishwasher leaking.
Remove screws holding the inside of the door. Set lid aside. Pull out the old foam insulation. Clean the area. Replace with new foam insulation. Put door back together.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brad from Austin, TX
- Parts Used:
- WP902899
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Detergent door wouldn't open
I used a voltmeter to see if 120 volts was present at the right time in the cycle; it was, so the actuator was the likely culprit. I ordered one on a Monday afternoon about 2:30, and it appeared on my doorstep Tuesday, shortly after noon! It took less than 15 minutes to replace the actuator - removing the 7 Phillips-head screws, lifting the panel, popping out the upper actuator, removing the two wires, putting them on the new actuator, popping it in and putting the panel back on. Worked like a charm. Happy wife . . .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Markleeville, CA
- Parts Used:
- WPY912900
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Replace broken Spray Arm
Popped off the plactic screen filter (3 screws). Droped in the new Spary Arm and put back together.
You guys are AWESOME! I ordered the part on a Wednesday afternoon and received it Thursday morning. So all and all I didn't even have to wash any dishes by hand.
You guys are AWESOME! I ordered the part on a Wednesday afternoon and received it Thursday morning. So all and all I didn't even have to wash any dishes by hand.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lawrence W. from Ventura, CA
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Leaking washer door
Pulled out the old gasket and pressed in the new one. No more leakage.
Was this instruction helpful to you?
Thank you for voting!