LDF6810WW-01 LG Dishwasher - Instructions

Uninstall dishwasher screws. Lay dishwasher on its side. Remove bottom plate. Remove old drain line. install new line. Test for leak. The trick was figuring out that I could only access the line through the bottom of the dishwasher.

First, PartSelect is great!; fast,& accurate. 1. Inside the dishwasher: remove trays. Remove (A050) lower water sprayer from bottom by pulling up. Remove (F191) top sprayer assembly by pulling away from clip holders. Remove (M110) by removing the holding screws. This part cover the whole sump and has kind-of an open screen circling the unit. Now you will see the white plastic impeller (M120) which is attached the the motor with one Phillips head screw. WARNING. The Phillips head screw (holding the impeller in place) is a REVERSE THREADED SCREW. Turn the screw CLOCKWISE to remove it. Then remove the impeller from the motor shaft. Underneath and outside the washer: Remove the bottom plate. Finally remove the motor by unscrewing the four holding screws and electrical wiring.

Replaced filter assembly, mesh, check valve and impeller. Root cause was tears in almost all the fine mesh filters on the filter assy. 30 minutes. caution: impeller screw is left hand thread. This "top of the line" unit, although quiet and very good at cleaning, has had leaks, needed a new motor and this last repair. I've been able to do all the repairs and avoid expensive service calls as all the problems started to happen shortly after the warranty was up.