D1454CFN (AASGBRS) LG Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Charles from DENNIS, MA
- Parts Used:
- 4970ED4004D, 4933DD3001B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Dishwasher door became heavy and would fall to the floor if you didn't hold it up.
Removed mounting screws from sides of disher. Removed broken piece of connector assy still attached to hinge. Attached new connector assy to hinge then looped it around pulley with spring attached to opposite end. Need both hands to pull spring up to side of tub and connect it. I would suggest replacing both connector assemblies while you have the dishwasher pulled out. Push dishwasher back in and mount with screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from NEW ORLEANS, LA
- Parts Used:
- 4970ED4004D, 4933DD3001B
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers, Wrench (Adjustable)
The hinge spring and/or connector assembly were not functioning, so the dishwasher door was extremely heavy.
Replacing the spring and connector assembly (the cord had frayed and broken) was easy and took only a matter of minutes to do. Wrestling the dishwasher in and out of its space under the counter was very difficult. Because my kitchen is compact, I had to move the refrigerator first, then disconnect the Romex cable and water lines from the dishwasher before I could pull it fully from under the counter. The side panels have screws in the front and the back, so the appliance had to be moved out until its back was exposed. But I got the job done and the door works just like a new one now!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from Katy, TX
- Parts Used:
- 3920DD3005H
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Dishwasher leaking; got AE error almost every other wash
The inside gasket deteriorates over time - However replacement is easy. the main thing you have to remember is after you remove the old gasket, install the new one starting at the middle top of the tub and work your way down both sides. Also, don't push the gasket all the way in...only enough to hold in place. When you close the door the gasket will form a better seal around the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ASHLAND, OR
- Parts Used:
- EAU62043401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- More than 2 hours
- Tools:
- Pliers, Screw drivers, Wrench set
was making noise and not cleaning dishes.
First do not watch the videos . They had you taking the insides all apart
when all you had to do is pull the unit out , twist the motor out and put the new one back in. Take nothing apart inside the dishwasher.
when all you had to do is pull the unit out , twist the motor out and put the new one back in. Take nothing apart inside the dishwasher.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from PLEASANT HILL, CA
- Parts Used:
- ABT72909202
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Socket set
Leak coming from pump/motor assembly
Ordered complete M030 Casing Assembly (RepairClinic Item # 4116143) after cleaning and testing rubber seal and pump assembly. Worked for two washes, then leak came back. To replace complete assembly, remove dishwasher from under sink, tip on back, disconnect all electrical and connectors to Case Assembly. Next, remove heater assemble (single nut) - this requires upward pulling to release the rubber washer and unit. Once removed unscrew the case assembly (four screws). That's it. Reverse the order to install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lenny from KIRTLAND, OH
- Parts Used:
- 4581DD3003C
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Second roller in on the left side was missing don't ask my how, pulling the bottom rack out the rack would dip down i had to lift it up to pull it the rest of the way out.
Ordered the roller from Parts Select, slid the roller over the little spindle sticking out of the bottom rack and snapped it in place. Job done in less than one minute.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Palm coast, FL
- Parts Used:
- 4933DD3001B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Door spring connector
Pull the dishwasher out from underneath the countertop took 2 minutes unscrewed the panel on the side one minute put the connector on one minute screwed the panel back on 1 minute put the dishwasher back underneath the counter two minutes very easy job
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from BOYNTON BEACH, FL
- Parts Used:
- 4581DD3003C
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Two Rollers missing on lower tray.
Snapped the rollers on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Amy from San Marcos, CA
- Parts Used:
- 4933DD3001B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Our dishwasher door would drop open and land on our feet.
My husband was able to slide the dishwasher out, and quickly replace the old connector assembly for the new ones. The old connector assembly had broken at the “rope”. Now the door opens slowly and is as good as new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ELLIJAY, GA
- Parts Used:
- 4933DD3001B
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door would fall to floor
Very easy just took out two screws that held the dishwasher to counter top.Then pulled dishwasher out just far enough that both door cables are exposed.The hardest part for me was getting the spring stretched enough to clip on.This was a easy installation for most people.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Beverly from LOMPOC, CA
- Parts Used:
- 3920DD3005H
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
There was a leak in the bottom left corner.
I am 77 years old and got it all on but the corners did not want to go in so I had to call my grandson and he got them in. It still leaked on the bottom left side. It is getting old (11 yrs) so I decided to get a new one. It is actually pretty simple to install, but it does take a little strength.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Blair from POTTSTOWN, PA
- Parts Used:
- 4933DD3001B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Hinge Cables Broke (Both), AGAIN!!
Cables have broken about every 3-6 months after original ones broke after 8 years. Removed front kick plate screws and remove kick plate, and remove two top screws holding Dishwasher to counter-top. Pull dishwasher out about 10 inches. Remove all broken parts and replace cables. Side dishwasher back in place and reinstall removed screws. I just hope these Cables last longer than the ones I had bought from another source. I have replaced those Cables 5 times already and hope these last MUCH longer. Delivery was very fast from PartSelect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jason from HOPKINTON, MA
- Parts Used:
- MEG62279201
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The purple piece (aka holder) that holds up the dish dividers broke.
Unsnapped broken holder and replaced with a new one. No tools necessary.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dale from ITASCA, IL
- Parts Used:
- 4581DD3003C
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Roller Assembly was broken
Took off the broken one and snap on the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from DALTON, OH
- Parts Used:
- 4933DD3001B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
DW door would fall when not latched
pulled dishwasher out of cabinet, removed side panel held by screws front and back, removed broken tension rope installed new rope, replaced side panel pushed dishwasher back into cabinet and fastened
to countertop, door works like new now, (the chief cook is happy as she can be)
to countertop, door works like new now, (the chief cook is happy as she can be)
Was this instruction helpful to you?
Thank you for voting!