KUDA23SY2 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Mike from Oakland, CA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water delivery tube to overhead sprayer punctured from age
I removed the roll out top wire rack of the dishwasher, turned it over and pulled the old punctured water supply tube off the force fit connectors on each end. I put a small amount of vaseline lubricant immediately inside the mouth of the new tube at each end. I pressed the ends of the new tube over the force fit connectors and tested them by shaking the pipe. I replaced the rack and fastened it into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara K. from Lorain, OH
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Hose kept slipping off - stretched out of shape from use and age.
Used a heat gun (or hair dryer could probably work)to stretch the ends of the hose to slip over areas to connect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alfred C from Mt Pleasant, PA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Part leaked due to a crack. & top rack dishes not being cleaned properly
Removed the old part. It came out with no problem
due to being brittle and cracked. This part was original to my 15 1/2 year old dishwasher.
Ran hot tap water in the sink and soaked the new "Rubber Water Delivery Tube" for about 5 min. I put a little dish washing liquid on dishwasher part where tube was to be slid onto. Including the soaking time,repair took less than 5 1/2 min.
I'm very pleased by the fact that my part arrived in a little over 1 1/2 days.
due to being brittle and cracked. This part was original to my 15 1/2 year old dishwasher.
Ran hot tap water in the sink and soaked the new "Rubber Water Delivery Tube" for about 5 min. I put a little dish washing liquid on dishwasher part where tube was to be slid onto. Including the soaking time,repair took less than 5 1/2 min.
I'm very pleased by the fact that my part arrived in a little over 1 1/2 days.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Marietta, GA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube was worn out. Burned out really.
Was lucky the part was available. I put liquid detergent on both ends of tube, then slid each end onto each sleeve. Works great now!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Royal from Elgin, IL
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old rubber water delivery tube was cracked and leaking.
I removed the old tube. I rubbed vegetable oil on the inside of both ends. The new tube slipped on with no
problem, and that was the end of the repair.
problem, and that was the end of the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Sharon, PA
- Parts Used:
- 4171221
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
cap broke
screwed it in. Closed the door. Voila, it works!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ricky from Lowell, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn Water delivery tube
Took the part to the rental house and took the old water delivery tube off by hand and installed the new water delivery tube by hand , it took less than 10 minutes and exactly the right part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mickey from Concordia, KS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube cracked
Put a little liquid dish washing soap on the inside of the tube, it slipped on very easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- milka from brooklyn, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
dishwasher had smoke
it was a very easy repair thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Santa Rosa Beach, FL
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
The old tube was worn out and had holes
Took the old one off then used canola oil to put on the inside of the tube and it went on easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- anne from clinton, MS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber Hose Had Holes In Itt
I heated both ends of rubber hose and applied a small amount of vaseline inside of tube and it slid on real easy. It took less than 5 minutes to finish the task.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from Chelan, WA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old peice was wore out and had holes and kept falling off.
I just put 1 drop of hand soap in each end of the new hose , that let it slide on EZ.
Was this instruction helpful to you?
Thank you for voting!
A roller came off the bottom washer tray in the dishwasher because of broken axle
I removed the broken axle with the help of a small screwdriver and replaced it with a new one. Then I installed a new roller, which was easy because all I had to do was push it on with my fingers.
One of the easiest repairs I've ever made on anything and now I'm happy because my wife is happy!
One of the easiest repairs I've ever made on anything and now I'm happy because my wife is happy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Bozeman, MT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dry rotted rubber tube
pulled off the old and put on the new. Great pictures on website so I got the right part the first time. Thanks!
Was this instruction helpful to you?
Thank you for voting!