KUDB230Y2 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Bill from Chelan, WA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old peice was wore out and had holes and kept falling off.
I just put 1 drop of hand soap in each end of the new hose , that let it slide on EZ.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Rancho Plaos Verdis, CA
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
The tube on the top split
Our old Kitchenaid Dishwasher was not getting the glasses on the top shelf clean. I looked and found the tube running to the washer arm under the top basket was split.
I replaced the tube. First I put dish soap in the ends of the new tube, so they slipped onto the other parts with only moderate force.
Now the dishwasher is making the glasses in the top basket clean again.
Regards,
Bob
I replaced the tube. First I put dish soap in the ends of the new tube, so they slipped onto the other parts with only moderate force.
Now the dishwasher is making the glasses in the top basket clean again.
Regards,
Bob
Was this instruction helpful to you?
Thank you for voting!
no pressure on top level. receiver fell off and melted
order new water tube and receiver and popped it on. No tools needed. Prefect fit. Washes like it did when it was new. Super fast shipping. 2 days.
Was this instruction helpful to you?
Thank you for voting!
Axles on lower rack broken
Very, very simple. The axles are nylon plastic and snap into the plastic-coated metal grid that forms the lower dishwasher rack. Over time they get brittle and break.
Replacement consists of snapping the old axle out of the rack and snapping the new one in. I replaced some of the wheels at the same time, as we had lost them. The wheels don't seem to wear out, so if you did this repair in time, you could re-use the wheels.
These little axles are EXPENSIVE ($3.50 each!), but for $30 you can replace all eight of them, and your dishwasher rack will work like new again!
Replacement consists of snapping the old axle out of the rack and snapping the new one in. I replaced some of the wheels at the same time, as we had lost them. The wheels don't seem to wear out, so if you did this repair in time, you could re-use the wheels.
These little axles are EXPENSIVE ($3.50 each!), but for $30 you can replace all eight of them, and your dishwasher rack will work like new again!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lorraine J from Freeport, ME
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The Rubber water tube on my dishwasher was all torn up and I knew if I didn't replace it I would be in trouble.
I ordered the part and I received it in just 2 days. I took the old rubber water tube off, put a little soap on each end of the new tube and had it in in under 10 minutes. I am a woman in her 60's and I did this myself!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ricky from Lowell, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn Water delivery tube
Took the part to the rental house and took the old water delivery tube off by hand and installed the new water delivery tube by hand , it took less than 10 minutes and exactly the right part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mickey from Concordia, KS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube cracked
Put a little liquid dish washing soap on the inside of the tube, it slipped on very easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- milka from brooklyn, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
dishwasher had smoke
it was a very easy repair thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Powell, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber tube for the top rack was rotted in half, not allowing the dishes to properly be cleaned.
First the water tube arrived two days earlier than what I was expecting. I pulled the old tube off and slipped the new tube on by hand. The dishes in the top rack are now a lot cleaner than they have been for the past couple of months. In the future if I need repair parts this is where I will be coming to get them.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alan from Spooner, WI
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water tube split and fell on drying element
Removed old tube, moistened both ends of new tube with hot water and slid over inlet and outlet holes. Repair done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debra from Windham, CT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
hose had blown a hole
just popped the old hose off and put the new one on. the part was shipped very quickly and I received it within a week even during the holidays
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- robert from glenmoore, PA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
worn rubber tube water feed to upper spin arm in dishwasher
The replacement worked fine, but the website could have been a bit more re-assuring in terms of showing the image of the part. It was not possible on the website to determine whether the piece was going to fit, as the piece as shown was flat/oval on both ends, where the fitting for the water feed is round. The site could have explained that this was flexible material that would form itself to the round feed connection. The measurements of the part should also be given. The price was right, so I bought it anyway, and hoped. As I have said, it DID work fine. You need to clarify the item on the website.
Was this instruction helpful to you?
Thank you for voting!
Rollers and axels were worn out.
Very easily!! I am 19 years old and repaired the dishwasher for my grandmother in about 15 minutes. Great products.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Winchester, MA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Tude was disintegrating.
Removed old tube.
New tube was a little tight, so I heated it with a hair dryer and used dish washing detergent - Joy - as a lubricant. Then the tube slipped on easily.
New tube was a little tight, so I heated it with a hair dryer and used dish washing detergent - Joy - as a lubricant. Then the tube slipped on easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- anne from clinton, MS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber Hose Had Holes In Itt
I heated both ends of rubber hose and applied a small amount of vaseline inside of tube and it slid on real easy. It took less than 5 minutes to finish the task.
Was this instruction helpful to you?
Thank you for voting!