KUDS01FLBL7 KitchenAid Dishwasher - Parts

If your dishwasher door is not opening or closing properly, it may be time to install a new balance kit. This part helps to support the weight of the door as it opens and closes. You should also check...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

This is a basket for washing flatware or silverware in your dishwasher. Note: This part has been updated by the manufacturer, it may appear different but will still function the same.

If your dishwasher is not cleaning your dishes properly, is not draining, or is noisy while operating, there may be an issue with your chopper assembly. The chopper is used to mince up food particles ...

This part contains the mounting clips and helps distribute water from the top of the dishwasher tub.

The door gasket provides a water tight seal, between the tub and the door, to keep water from leaking out of your dishwasher. If the dishwasher is leaking you may need to replace the door gasket. Thi...

When replacing these fuses the wire harness must be replaced as well. It is located in the control panel. The harness is included with this part now.

This part releases the detergent and rinse aid into the dishwasher.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.

Sold individually. Used with the heating element.

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.