KUDI220WWH4 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
no pressure on top level. receiver fell off and melted
order new water tube and receiver and popped it on. No tools needed. Prefect fit. Washes like it did when it was new. Super fast shipping. 2 days.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Schaumburg, IL
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
old water tube became brittle and split down it's length
Removed by hand the old water tube and pushed the new tube on. It was no big deal. Itook about 3 mins.
Was this instruction helpful to you?
Thank you for voting!
old part corroded and fell off
This was sooo easy. The key was the "tip" on this website to lubricate the parts with dish soap. They slid right on. It works perfectly. Most important, I am a Hero with the wife ... that gets special rewards!!
Was this instruction helpful to you?
Thank you for voting!
Axles on lower rack broken
Very, very simple. The axles are nylon plastic and snap into the plastic-coated metal grid that forms the lower dishwasher rack. Over time they get brittle and break.
Replacement consists of snapping the old axle out of the rack and snapping the new one in. I replaced some of the wheels at the same time, as we had lost them. The wheels don't seem to wear out, so if you did this repair in time, you could re-use the wheels.
These little axles are EXPENSIVE ($3.50 each!), but for $30 you can replace all eight of them, and your dishwasher rack will work like new again!
Replacement consists of snapping the old axle out of the rack and snapping the new one in. I replaced some of the wheels at the same time, as we had lost them. The wheels don't seem to wear out, so if you did this repair in time, you could re-use the wheels.
These little axles are EXPENSIVE ($3.50 each!), but for $30 you can replace all eight of them, and your dishwasher rack will work like new again!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Bozeman, MT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dry rotted rubber tube
pulled off the old and put on the new. Great pictures on website so I got the right part the first time. Thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Sagamore Hills, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber hose running to the upper shelf discharge fan rotted out.
It was 94 degrees that day so I set the rubber hose outside in the sun to loosen it up, make it more plyable. I then mixed up some soapy water and doused the ends of the hose with the soapy water and slid the hose right onto the fittings.
There was a small hole in the hose which was not discussed in the directions. I assumed the hole should be installed on the down side to let water drain out after the dishwasher is finished. This will reduce the chance of bacteria building in the hose.
I read the installation tips before I started and picked up the soap mix and heating up the hose before installation. Can be accomplished with a hair dryer if it is not 94+ degrees outside!!!
Thanks,
Jim
There was a small hole in the hose which was not discussed in the directions. I assumed the hole should be installed on the down side to let water drain out after the dishwasher is finished. This will reduce the chance of bacteria building in the hose.
I read the installation tips before I started and picked up the soap mix and heating up the hose before installation. Can be accomplished with a hair dryer if it is not 94+ degrees outside!!!
Thanks,
Jim
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Santa Rosa Beach, FL
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
The old tube was worn out and had holes
Took the old one off then used canola oil to put on the inside of the tube and it went on easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- WILLARD from Black River, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water hose would fall off
I had repaired the hose with duck tape several times, and finally was able to convince my husband to look up the model number etc. went on line to see if I could locate a dealer to get the hose, and that was so easy,
Ordered it, it came in 2 days, and my dishwasher works great again.
It was so easy just took off the old hose and snapped in the new one.
Ordered it, it came in 2 days, and my dishwasher works great again.
It was so easy just took off the old hose and snapped in the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alfred C from Mt Pleasant, PA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Part leaked due to a crack. & top rack dishes not being cleaned properly
Removed the old part. It came out with no problem
due to being brittle and cracked. This part was original to my 15 1/2 year old dishwasher.
Ran hot tap water in the sink and soaked the new "Rubber Water Delivery Tube" for about 5 min. I put a little dish washing liquid on dishwasher part where tube was to be slid onto. Including the soaking time,repair took less than 5 1/2 min.
I'm very pleased by the fact that my part arrived in a little over 1 1/2 days.
due to being brittle and cracked. This part was original to my 15 1/2 year old dishwasher.
Ran hot tap water in the sink and soaked the new "Rubber Water Delivery Tube" for about 5 min. I put a little dish washing liquid on dishwasher part where tube was to be slid onto. Including the soaking time,repair took less than 5 1/2 min.
I'm very pleased by the fact that my part arrived in a little over 1 1/2 days.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Marietta, GA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube was worn out. Burned out really.
Was lucky the part was available. I put liquid detergent on both ends of tube, then slid each end onto each sleeve. Works great now!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Royal from Elgin, IL
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old rubber water delivery tube was cracked and leaking.
I removed the old tube. I rubbed vegetable oil on the inside of both ends. The new tube slipped on with no
problem, and that was the end of the repair.
problem, and that was the end of the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vernon from Pleasant Grove, UT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber tube on upper tray was disintigrating...
The tube had a huge hole in it. It was very easy to replace - I just pulled off the old one and put on the new. The cool thing was how easy it was to find the exact part I needed online in less than 5 minutes. Gotta love the internet!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stephanie from Rye, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
hose had a hole and was rotting
I pulled out the old hose and pushed in the new one. Took a little muscle, but was glad that it fit. On line site very helpful with description so that it fit perfectly!
Was this instruction helpful to you?
Thank you for voting!
wheels and axles had broken off rack - not able to slide in/out smoothly anymore
Simply popped on new axles and wheels and dishwasher works like new!
Was this instruction helpful to you?
Thank you for voting!