KUDB230Y0 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gerald from Woodburn, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Hose was worn out, had holes in it.
First removed old hose from the upper rack. Used hair dryer to heat the hose up ( hose was a little stiff) and installed hose. It's pretty simple to install, I didn't even have to unload the dishwasher
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ELLEN from TUSCALOOSA, AL
- Parts Used:
- WP4162322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
dishwasher rack rusted
It was easy to remove rack from dishwasher. I screwed on rollers and it was like new!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sherry from Hollywood, FL
- Parts Used:
- 4162321
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
3 roller axles were broken on bottom dishwasher rack.
I pulled off the broken parts and snapped on the new axles, then replaced the wheels. Very simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- connie from Longboat Key, AL
- Parts Used:
- 4162321
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
wheels on dishwasher rack falling off and apart, so i couldn't roll the bottom rack in and out
i pulled the rack out, took off the old parts then added the new ones. it was quick and simple. i needed no tools and my package of parts arrived quicker than i thought. thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Glenn from Nashua, NH
- Parts Used:
- 4171566
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Upper Rack would not wash
I pulled back the tray and inserted the funnel like part into the rubber tube. That was it. I wonder where the original part disappeared to.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Madolyn from Elkmont, AL
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Rubber water tube had worn out.
I just slipped the old, worn out tube off, warmed the new one in some hot water for a few minutes to make it more pliable, sprayed some non-stick spray on the end connecting in the back, and slipped it on. Piece of cake!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Colleen from Tualatin, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
No water was getting to the upper rack of the dishwasher
I removed the old tube by hand (it fell apart) I just worrked the new softer tube over the openings on each end and it was fixed! I did have to warm the new tube with warm water to squeeze it over the tubes but it was easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Norton, MA
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Glasses on top rack of the dishwasher had soap film on the inside. The rubber distribution hose under the top rack had rotted and split. Didn't see it right away because it split on the bottom.
Part was easy to locate on the website. Photo on the measurement grid was the key after entering the maker and model number. I have found refrigerator parts the same way on this site. Sliced the old rotten hose to remove it. The new hose only had to be slipped over the connections. I soaped the ends of the tube to make the installation easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lloyd from Clifton, VA
- Parts Used:
- 675806
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers
Dishwasher not draining
Actually I ordered the drain and wash impeller kit because it was listed as the #1 cause of failure to drain. I then hired a plumber to install it. He did so and that didn't solve the problem. So I was about to buy a new dishwasher. I then noticed that the second most frequent cause was a problem with the "dishwasher drain check valve." I watched the "partselect" video on how to change that. I didn't have a new one but I thought I would take out the part and see what I could learn. As it turned out it was blocked by a little piece of what appeared to be a walnut chip. I cleaned it out reinstalled the drain check valve and the problem was solved.
Was this instruction helpful to you?
Thank you for voting!
Old water delivery tube brittle & full of holes poor pressure
Used a utility knife to cut the old tube . It was hard & brittle & full of holes. The new tube is not very flexible. Ran it under hot water to soften it up. I used liquid soap on the ends . This made the repair easy. Slipped right on, at both ends. Saved $200 by doing it myself. Took ten minutes.With more pressure from the new tube, the dishwasher is cleaning much better.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rene from New Berlin, WI
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber Water Delivery Tube had decayed over time.
Manually remove old tube and simply replace with new tube - no tools!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from buffalo, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
upper rack propeller jets lost power
I removed the old, brittle and leaky water delivery tube by hand and at the outlet and at the inlet end, by cutting it away with an exacto knife. I then heated the new tube under hot water and coated each end with dishwasher soap. With only a modest amount of manipulation, both ends slipped easily into place and the hose was immediately secure and operable. My wife, who didn't witness my efforts, thought I was a genius.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Beverly Hills, MI
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Hole in the water delivery tube
Pulled off old tube and slipped on new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- robert from cranston, RI
- Parts Used:
- 4169400
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
dishwasher not adaptable for change of panel
removed screws from dishwasher and discovered i could replace panel because of door type
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- michael from topeka, KS
- Parts Used:
- 4162321
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
roller axle broken, roller fell off
first-removed all axles from one side of rack. replace with new ones, replace rollers. repeat for other side of rack. VIOLA!!
Was this instruction helpful to you?
Thank you for voting!