KUDP01DLBS2 KitchenAid Dishwasher - Parts

New Black Single Metal Access Panel Replacement Kit. Replaces old two part toe kick plates. Reuse insulation off old panel or see Recommended Parts.

Includes power cord and all necessary parts needed for complete installation of cord.

This part is the door actuator for your dishwasher. It is made of black plastic and is approximately 3 inches long and 3 inches wide at its widest point. The door actuator is found in the control pane...

Shield

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

This is a basket for washing flatware or silverware in your dishwasher.

This gray dishrack track stop is located on the upper dishrack track. It refrains the upper dishrack from pulling out too far.

16ml

This part is used to cover the chopper blades.