KUDM01TJBL0 KitchenAid Dishwasher - Parts

If your dishwasher door is not opening or closing properly, it may be time to install a new balance kit. This part helps to support the weight of the door as it opens and closes. You should also check...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

This black rubber gasket is a genuine OEM replacement part for your dishwasher door. The gasket helps to provide a tight seal between the door and the tub, preventing water from leaking while the appl...

This part contains the mounting clips and helps distribute water from the top of the dishwasher tub.

Sold individually.

When replacing these fuses the wire harness must be replaced as well. It is located in the control panel. The harness is included with this part now.

This part releases the detergent and rinse aid into the dishwasher.

NOTE: This part is no longer available in white or biscuit. HANDLE only.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.

Sold individually.

Sold individually. Used with the heating element.

The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.