KUDS22HT1 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Mike from Oakland, CA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water delivery tube to overhead sprayer punctured from age
I removed the roll out top wire rack of the dishwasher, turned it over and pulled the old punctured water supply tube off the force fit connectors on each end. I put a small amount of vaseline lubricant immediately inside the mouth of the new tube at each end. I pressed the ends of the new tube over the force fit connectors and tested them by shaking the pipe. I replaced the rack and fastened it into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara K. from Lorain, OH
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Hose kept slipping off - stretched out of shape from use and age.
Used a heat gun (or hair dryer could probably work)to stretch the ends of the hose to slip over areas to connect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Murray from Hendrsonville, NC
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber tube deteriorated and top rack kept jamming
First I pulled off the tube that was hanging down and obstructing the rotation of the top spinner. Then I just reinserted the new tube. I'm a "do it your selfer" and I usually fix things by my self. But the few times that I've failed lived forever in my wife's memory. She dreaded my fooling with a machine that had outlived it's life. I promised that the job would only take about five minutes. She heard this before and resigned herself to having parts all over the kitchen floor and a full day of catastrophe. There is nothing like a satisfied wife.Thanks to You and your Staff, I have now regained my rightful place as her trusted HERO.. ,
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Winchester, MA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Tude was disintegrating.
Removed old tube.
New tube was a little tight, so I heated it with a hair dryer and used dish washing detergent - Joy - as a lubricant. Then the tube slipped on easily.
New tube was a little tight, so I heated it with a hair dryer and used dish washing detergent - Joy - as a lubricant. Then the tube slipped on easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Powell, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber tube for the top rack was rotted in half, not allowing the dishes to properly be cleaned.
First the water tube arrived two days earlier than what I was expecting. I pulled the old tube off and slipped the new tube on by hand. The dishes in the top rack are now a lot cleaner than they have been for the past couple of months. In the future if I need repair parts this is where I will be coming to get them.
Was this instruction helpful to you?
Thank you for voting!
Rollers and axels were worn out.
Very easily!! I am 19 years old and repaired the dishwasher for my grandmother in about 15 minutes. Great products.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- MORTON from WOODBURY, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
not cleaning well
I placed the hose on one side after placing one end in boiling water. I placed the other end in the hot water and pushed it on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Downers Grove, IL
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber water tube was worn out and the water was spraying everywhere inside the dishwasher
All I had to do was remove the damaged hose and replace it with the new hose. It took all of 5 minutes. The dishwasher is working like new!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LESLIE from SOUTH CHARLESTON, WV
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water delivery tube disintegrated due to age
Removed the old tube with the aid of a knife to cut one end off the fitting. Then I lubed each end of the tube with dish washing soap and slipped them on. Done in 10 minutes. Easier to do if the top rack is removed for better access to the hose connections.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Francis H. from New Brighton, PA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
old tube rotted away, top rack was no cleaning
took old tube of and heaten new tube to soften it. put some plumber grease on ends and slipped it on. longest time was boiling the water.
Was this instruction helpful to you?
Thank you for voting!
broken roller weels on bottom dish rack
I simply removed the broken wheel brackets and snapped new ones on. then the wheel just sliped on. It took some good hand strength.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- douglas from stocholm, NJ
- Parts Used:
- WP9743413
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Socket set, Wrench set
water not going into dishwasher
While replacing the water valve I broke the float switch. Ordered the switch....it was here in 2 days. Great service! Will use this company again....I hope not all that much. lol
I am a retired Sears service tech, but not a dishwaher tech.
Love Parts Select!
Thanks guys,
Doug
I am a retired Sears service tech, but not a dishwaher tech.
Love Parts Select!
Thanks guys,
Doug
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Norman, OK
- Parts Used:
- WP4162568
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Detergent dispenser failed to open
Removed the door cover and replaced the bi-metal.
Was this instruction helpful to you?
Thank you for voting!
Old float stem had fine thread new one had corse and did not supply nut so had to use old one over.
put new switch and new gasket on old float stem with old nut. but it still overflows about 1/2 cup of water through stem
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandi from Farmingville, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Water did not leave dishwasher it also leaked on floor
Went very well. The repair tech had to pull out dishwasher, check for a clog drained the water out of dishwasher by pumping into a container. All good, not sure why it did not drain for me. Repair tech got it working. I am happy.
Was this instruction helpful to you?
Thank you for voting!