KUDI22XX2 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Corinne from El Granada, CA
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
Old water tube had worn through and was falling off.
Removed old water tube and replaced it with the new one. Hard part was logistically trying to put it below the rack and it obviously it had to fit very tight and it was quite difficult to get in place, but I did it! Thanks to your easy to use website and excellent service. I was proud of myself for doing the whole job start to finish, and my husband was even more impressed. Only downside to that is that I think he'll be playing more golf, while I do the repair work from now on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from Lorain, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn out rubber delivery tube
Slipped old one off slid new one on . Took about one minute. Held well and is washing so much better now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debra from Windham, CT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
hose had blown a hole
just popped the old hose off and put the new one on. the part was shipped very quickly and I received it within a week even during the holidays
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Powell, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber tube for the top rack was rotted in half, not allowing the dishes to properly be cleaned.
First the water tube arrived two days earlier than what I was expecting. I pulled the old tube off and slipped the new tube on by hand. The dishes in the top rack are now a lot cleaner than they have been for the past couple of months. In the future if I need repair parts this is where I will be coming to get them.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alan from Spooner, WI
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water tube split and fell on drying element
Removed old tube, moistened both ends of new tube with hot water and slid over inlet and outlet holes. Repair done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janice from Napa, CA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dishwasher not cleaning as rubbr water tube cracked
I removed clips on the end of the rack, removed the rack, and pulled old tube off. Used plain water as a lubricant to ease replacement of new tube on the dilated end. Very easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sherrie from Mount Kisco, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Cracked water delivery tube
Replaced the tube. It was relatively easy although it did take a small bit of squeezing/reshaping the newer rubber tubing to get it to fit on the outlet (it was a bit snug.)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- WILLARD from Black River, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water hose would fall off
I had repaired the hose with duck tape several times, and finally was able to convince my husband to look up the model number etc. went on line to see if I could locate a dealer to get the hose, and that was so easy,
Ordered it, it came in 2 days, and my dishwasher works great again.
It was so easy just took off the old hose and snapped in the new one.
Ordered it, it came in 2 days, and my dishwasher works great again.
It was so easy just took off the old hose and snapped in the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Sharon, PA
- Parts Used:
- 4171221
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
cap broke
screwed it in. Closed the door. Voila, it works!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Terrance from Burlington, VT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Hose was badly cracked from old age
I removed the upper rack from the dishwasher by popping the two rack track stops out of the rack tracks. The old tube came off easily, and the new tube went on very nicely, after lubing each end with a dab of liquid dish soap. I put the rack back on its tracks , popped the track stops back in and my dishwasher was back in business.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Merdell from Montgomery, TX
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
hole in the tube, wear and tear on it
I removed the old tube--I had taped over the hole. I didn't quite have the hand strength to fit over the ends and push the new tube into place. So, my husband did that at both ends without a problem. I'm relying on PartSelect for when I need parts for my 13 year-old appliances.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James R from Springfield, MO
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
rubber water tube disintegrating
I ran the tube under warm water and it was very easy to connect. I would have done it a lot sooner if I had known how easy it would be to find the part and install it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Oakland, CA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water delivery tube to overhead sprayer punctured from age
I removed the roll out top wire rack of the dishwasher, turned it over and pulled the old punctured water supply tube off the force fit connectors on each end. I put a small amount of vaseline lubricant immediately inside the mouth of the new tube at each end. I pressed the ends of the new tube over the force fit connectors and tested them by shaking the pipe. I replaced the rack and fastened it into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara K. from Lorain, OH
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Hose kept slipping off - stretched out of shape from use and age.
Used a heat gun (or hair dryer could probably work)to stretch the ends of the hose to slip over areas to connect.
Was this instruction helpful to you?
Thank you for voting!