KUDB22HT1 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from Powell, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber tube for the top rack was rotted in half, not allowing the dishes to properly be cleaned.
First the water tube arrived two days earlier than what I was expecting. I pulled the old tube off and slipped the new tube on by hand. The dishes in the top rack are now a lot cleaner than they have been for the past couple of months. In the future if I need repair parts this is where I will be coming to get them.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janice from Napa, CA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dishwasher not cleaning as rubbr water tube cracked
I removed clips on the end of the rack, removed the rack, and pulled old tube off. Used plain water as a lubricant to ease replacement of new tube on the dilated end. Very easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from Nine Mile Falls, WA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn out water tube.
Took old one off and put new one on, about a 4 minute job.
The part was about 1/3 of the cost if I had bought it local.
The part was about 1/3 of the cost if I had bought it local.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Winchester, MA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Tude was disintegrating.
Removed old tube.
New tube was a little tight, so I heated it with a hair dryer and used dish washing detergent - Joy - as a lubricant. Then the tube slipped on easily.
New tube was a little tight, so I heated it with a hair dryer and used dish washing detergent - Joy - as a lubricant. Then the tube slipped on easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Bozeman, MT
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dry rotted rubber tube
pulled off the old and put on the new. Great pictures on website so I got the right part the first time. Thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Sagamore Hills, OH
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber hose running to the upper shelf discharge fan rotted out.
It was 94 degrees that day so I set the rubber hose outside in the sun to loosen it up, make it more plyable. I then mixed up some soapy water and doused the ends of the hose with the soapy water and slid the hose right onto the fittings.
There was a small hole in the hose which was not discussed in the directions. I assumed the hole should be installed on the down side to let water drain out after the dishwasher is finished. This will reduce the chance of bacteria building in the hose.
I read the installation tips before I started and picked up the soap mix and heating up the hose before installation. Can be accomplished with a hair dryer if it is not 94+ degrees outside!!!
Thanks,
Jim
There was a small hole in the hose which was not discussed in the directions. I assumed the hole should be installed on the down side to let water drain out after the dishwasher is finished. This will reduce the chance of bacteria building in the hose.
I read the installation tips before I started and picked up the soap mix and heating up the hose before installation. Can be accomplished with a hair dryer if it is not 94+ degrees outside!!!
Thanks,
Jim
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- milka from brooklyn, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
dishwasher had smoke
it was a very easy repair thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- anne from clinton, MS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber Hose Had Holes In Itt
I heated both ends of rubber hose and applied a small amount of vaseline inside of tube and it slid on real easy. It took less than 5 minutes to finish the task.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from Chelan, WA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old peice was wore out and had holes and kept falling off.
I just put 1 drop of hand soap in each end of the new hose , that let it slide on EZ.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Catherine from Twin Lakes, WI
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube to the top rack that supplies water
The tube had holes from being used but the dishwasher still works great. I researched this part and it was a great price and really easy to fix. The picture looks different than what the tube looks like in the dishwasher but it is correct. Definitely put soap on the ends to help glide it on. Took me 2 minutes to fix.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ricky from Lowell, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn Water delivery tube
Took the part to the rental house and took the old water delivery tube off by hand and installed the new water delivery tube by hand , it took less than 10 minutes and exactly the right part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mickey from Concordia, KS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube cracked
Put a little liquid dish washing soap on the inside of the tube, it slipped on very easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stephanie from Rye, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
hose had a hole and was rotting
I pulled out the old hose and pushed in the new one. Took a little muscle, but was glad that it fit. On line site very helpful with description so that it fit perfectly!
Was this instruction helpful to you?
Thank you for voting!
wheels and axles had broken off rack - not able to slide in/out smoothly anymore
Simply popped on new axles and wheels and dishwasher works like new!
Was this instruction helpful to you?
Thank you for voting!