4KUDC220T1 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- David from St. Marys, KS
- Parts Used:
- 4162321
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
4 pcs broken & would not hold wheel on Basket.
Push off - Push on new plastic Part. Very stiff. Used a wooden spoon handle!!! Job done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from Durham, NC
- Parts Used:
- WP9741251
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
The left mounting bracket had broken..
I had called an appliance repairman...I gave him the model #- he called me back in 2 seconds and said it was too old.. no parts available.. wanted to charge me $100 to come and look.I found parts select online. the part came in one day... and my handy man/put the new bracket on.. the dishwasher was put in new in 1991 and still works like a charm..thanks thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald A from Los Angeles, CA
- Parts Used:
- WP4171000
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable), Wrench set
Water wouldn't activate when button pushed to activate
The previous pump needed to be removed, install new. New pump mounting bracket hit existing mounting bracket from an adjacent part. 1. Wire contacts removed 2. Copper incoming line was disconnected from brass elbow. 3. Hose to pump removed using pliers for wire clamp, and flat head screw driver to prod hose off. The used pump is now in one's hand. The new pump would not fit using existing screw holes. The mounting bracket was moved to the left, using the one pre-existing hole and right hole in mounting bracket. The left hole of the mounting bracket was used as location for another hole to be bored/drilled out. Two drill bits of different sizes were used, along with the same sheet metal screw which was in previous mounting bracket assembly. Pump design has been changed from two wire coils to one wire coil. 1. The hose was re-connected using pliers. 2. Copper compression fitting lined up with brass elbow again. 3. Two Wire contacts were attached; previously there were Three contacts. 4. Second screw was added in newly bored hole. Plenty of room moving to the left. There is one loose wire contact.
Was this instruction helpful to you?
Thank you for voting!