KUDB21S0 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from Fort Collins, CO
- Parts Used:
- WP8189867
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Wrench set
light wont come on
Well, when you put the back cover on and screw it down make sure you have nothing touching the white wire leading to the oven light. I did and it blew the push switch when I threw the 220 breaker. Actually, the light was on when I came in the room, but when I pushed the switch on the front panel it sparked in the rear and popped the breaker. Then I saw the short and when I tested the switch it would not click. The install was fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Linda from Moundsville, WV
- Parts Used:
- 4162321
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
roller axles had broken releasing wheels
I ordered 8 new axles and used old wheels. I broke off the remaining axle parts left on the wire lower basket with just my hands, and then popped on the new axles. This was done without tools; just needed significant pressure to pop the axles onto the coated wire. The wheels popped onto the axles with a little pressure. Make sure you have the right side of the wheel out. I simply looked at the remaining working wheels before install began to make sure which side goes out. Very easy install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from WARREN, NJ
- Parts Used:
- 279570
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dryer door latch broke and door wouldn’t stay shut.
Jimmied out the latch using two screw drivers to get under the edges. Pushed the new piece in. Voila! Took 2 minutes for what my repair man told me would cost about $200 to fix. Unbelievable!!( I first watched some YouTube videos to get the idea )
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from Boynton Beach, FL
- Parts Used:
- 4172117
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Diswasher parts worn out.
My parts really did not require tools to install , although the dishrack rollers may require some persuasion for someone with weak hands. The ease of ordering online and delivery was excellent. I will definately be using your service for all my appliance needs
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- connie from Longboat Key, AL
- Parts Used:
- 4162321
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
wheels on dishwasher rack falling off and apart, so i couldn't roll the bottom rack in and out
i pulled the rack out, took off the old parts then added the new ones. it was quick and simple. i needed no tools and my package of parts arrived quicker than i thought. thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sherry from Hollywood, FL
- Parts Used:
- 4162321
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
3 roller axles were broken on bottom dishwasher rack.
I pulled off the broken parts and snapped on the new axles, then replaced the wheels. Very simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Little Falls, NJ
- Parts Used:
- 4172117
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
The racks were rusting and staining the dishes.
The rack you sent me didn't have the plastic wheels on the bottom so I had to pry the old ones off and use them.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Colleen from Tualatin, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
No water was getting to the upper rack of the dishwasher
I removed the old tube by hand (it fell apart) I just worrked the new softer tube over the openings on each end and it was fixed! I did have to warm the new tube with warm water to squeeze it over the tubes but it was easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Madolyn from Elkmont, AL
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Rubber water tube had worn out.
I just slipped the old, worn out tube off, warmed the new one in some hot water for a few minutes to make it more pliable, sprayed some non-stick spray on the end connecting in the back, and slipped it on. Piece of cake!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Norton, MA
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Glasses on top rack of the dishwasher had soap film on the inside. The rubber distribution hose under the top rack had rotted and split. Didn't see it right away because it split on the bottom.
Part was easy to locate on the website. Photo on the measurement grid was the key after entering the maker and model number. I have found refrigerator parts the same way on this site. Sliced the old rotten hose to remove it. The new hose only had to be slipped over the connections. I soaped the ends of the tube to make the installation easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Veronica from Richmond, VA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber Water Tube disintegrated from age
The whole operation took about 5 minutes which included opening the package! Sprayed some vegetable spray inside the opening of the water tube that attached to the spray connection and it slipped right on. Absolutely amazing and I feel like I have a brand new dishwater! My dishes are definitely cleaner too! Thank you Parts Select for posting how to instructions!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Glenn from Nashua, NH
- Parts Used:
- 4171566
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Upper Rack would not wash
I pulled back the tray and inserted the funnel like part into the rubber tube. That was it. I wonder where the original part disappeared to.
Was this instruction helpful to you?
Thank you for voting!
Broken Supply Tube to Upper Spray Arm
Very easy to do repair. Identifying the problem took more time than the repair. Simply use soap and water to inset the tube into the spray arm receiver and the spray arm. Saved a $120.00 service call by doing myself and performing a little detective work. Quick delivery of items from Part select!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Sewell, NJ
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
oLD WATER TUBE TORN AT CONNECTION
Used screwdriver to pry off other end of water tube. Kind of cooked on over the years and rear connection point is on a part that is not real strong so you have to be careful to not break or bend the connection. New tube is very tight to get on so putting it on required using the blade of the screwdriver to get the tube to streatch over the two connection points, but not real difficult. Now it's good as new!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gerald from Woodburn, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Hose was worn out, had holes in it.
First removed old hose from the upper rack. Used hair dryer to heat the hose up ( hose was a little stiff) and installed hose. It's pretty simple to install, I didn't even have to unload the dishwasher
Was this instruction helpful to you?
Thank you for voting!