KUDA23SB0 KitchenAid Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James R from Springfield, MO
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
rubber water tube disintegrating
I ran the tube under warm water and it was very easy to connect. I would have done it a lot sooner if I had known how easy it would be to find the part and install it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Oakland, CA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water delivery tube to overhead sprayer punctured from age
I removed the roll out top wire rack of the dishwasher, turned it over and pulled the old punctured water supply tube off the force fit connectors on each end. I put a small amount of vaseline lubricant immediately inside the mouth of the new tube at each end. I pressed the ends of the new tube over the force fit connectors and tested them by shaking the pipe. I replaced the rack and fastened it into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara K. from Lorain, OH
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Hose kept slipping off - stretched out of shape from use and age.
Used a heat gun (or hair dryer could probably work)to stretch the ends of the hose to slip over areas to connect.
Was this instruction helpful to you?
Thank you for voting!
Replace 2 Wheels
One of the axles broke off, requiring no removal. The other wheel broke off, but the axle remained. That required squeezing (pliers) to push out. Replacement was easy; just put wheel onto axle and push axle through mounting space. Total: 5 minute job.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Rancho Plaos Verdis, CA
- Parts Used:
- 4171544
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
The tube on the top split
Our old Kitchenaid Dishwasher was not getting the glasses on the top shelf clean. I looked and found the tube running to the washer arm under the top basket was split.
I replaced the tube. First I put dish soap in the ends of the new tube, so they slipped onto the other parts with only moderate force.
Now the dishwasher is making the glasses in the top basket clean again.
Regards,
Bob
I replaced the tube. First I put dish soap in the ends of the new tube, so they slipped onto the other parts with only moderate force.
Now the dishwasher is making the glasses in the top basket clean again.
Regards,
Bob
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alfred C from Mt Pleasant, PA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Part leaked due to a crack. & top rack dishes not being cleaned properly
Removed the old part. It came out with no problem
due to being brittle and cracked. This part was original to my 15 1/2 year old dishwasher.
Ran hot tap water in the sink and soaked the new "Rubber Water Delivery Tube" for about 5 min. I put a little dish washing liquid on dishwasher part where tube was to be slid onto. Including the soaking time,repair took less than 5 1/2 min.
I'm very pleased by the fact that my part arrived in a little over 1 1/2 days.
due to being brittle and cracked. This part was original to my 15 1/2 year old dishwasher.
Ran hot tap water in the sink and soaked the new "Rubber Water Delivery Tube" for about 5 min. I put a little dish washing liquid on dishwasher part where tube was to be slid onto. Including the soaking time,repair took less than 5 1/2 min.
I'm very pleased by the fact that my part arrived in a little over 1 1/2 days.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Marietta, GA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube was worn out. Burned out really.
Was lucky the part was available. I put liquid detergent on both ends of tube, then slid each end onto each sleeve. Works great now!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Royal from Elgin, IL
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old rubber water delivery tube was cracked and leaking.
I removed the old tube. I rubbed vegetable oil on the inside of both ends. The new tube slipped on with no
problem, and that was the end of the repair.
problem, and that was the end of the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Sharon, PA
- Parts Used:
- 4171221
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
cap broke
screwed it in. Closed the door. Voila, it works!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ricky from Lowell, OR
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn Water delivery tube
Took the part to the rental house and took the old water delivery tube off by hand and installed the new water delivery tube by hand , it took less than 10 minutes and exactly the right part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mickey from Concordia, KS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Tube cracked
Put a little liquid dish washing soap on the inside of the tube, it slipped on very easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- milka from brooklyn, NY
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
dishwasher had smoke
it was a very easy repair thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Santa Rosa Beach, FL
- Parts Used:
- 4171544
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
The old tube was worn out and had holes
Took the old one off then used canola oil to put on the inside of the tube and it went on easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- anne from clinton, MS
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber Hose Had Holes In Itt
I heated both ends of rubber hose and applied a small amount of vaseline inside of tube and it slid on real easy. It took less than 5 minutes to finish the task.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from Chelan, WA
- Parts Used:
- 4171544
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The old peice was wore out and had holes and kept falling off.
I just put 1 drop of hand soap in each end of the new hose , that let it slide on EZ.
Was this instruction helpful to you?
Thank you for voting!