KUDC03ITBL3 KitchenAid Dishwasher - Parts

This complete float switch kit is designed to regulate water levels in your dishwasher by activating the shutoff mechanism once the water reaches a specific height. The kit includes a switch, lever, s...

New Black Single Metal Access Panel Replacement Kit. Replaces old two part toe kick plates. Reuse insulation off old panel or see Recommended Parts.

Includes power cord and all necessary parts needed for complete installation of cord.

This part is the door actuator for your dishwasher. It is made of black plastic and is approximately 3 inches long and 3 inches wide at its widest point. The door actuator is found in the control pane...

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

The spray arm in your dishwasher spins and sprays the water that is used to clean your dishes. If the spray arm is damaged, your dishwasher will not clean properly, and you will need to replace it. Ma...

This track attaches to the inside of the tub for the upper rack to glide in and out.

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

The lower spray arm hub sits inside the dishwasher at the base, and feeds water into the lower spray arm. The arm hub is made of plastic and measures 3 inches long by 1.5 inches wide. If the spray arm...

This is a flexible drain hose that is 12 feet long.