66516502200 Kenmore Dishwasher - Parts

This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that...

This genuine OEM upper spray arm mount is used to hold the spray arm to the top rack in your dishwasher. This part is made of plastic and has been redesigned by the manufactured so it may look differe...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

This is a genuine OEM replacement silverware basket for your dishwasher. The basket measures approximately 19.5 inches long, 4 inches wide, and 9 inches high. It is made of gray-colored plastic and in...

This black rubber gasket is a genuine OEM replacement part for your dishwasher door. The gasket helps to provide a tight seal between the door and the tub, preventing water from leaking while the appl...

The friction sleeve, sometimes called a friction pad, is made of a flexible black plastic and measures a bit over one inch in length. It is designed to reduce the friction between the hinge and the do...

When replacing these fuses the wire harness must be replaced as well. It is located in the control panel. The harness is included with this part now.

This part releases the detergent and rinse aid into the dishwasher.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.

Sold individually.

Sold individually. Used with the heating element.

This part is the top spinner located at the very top of the wash tub. Water passes through all the spinners causing it to dispense all around the tub.