66513255K114 Kenmore Dishwasher - Parts

If your dishwasher door is not opening or closing properly, it may be time to install a new balance kit. This part helps to support the weight of the door as it opens and closes. You should also check...

The genuine OEM replacement rack stop clip is for dishwashers. It measures just over an inch and is made of gray plastic. The purpose of this part is to prevent your dishwasher rack from pulling out t...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

If there is still water left in your dishwasher after it has finished running, there may be an issue with your drain pump. The pump is designed to remove water from the tub, and if that is not happeni...

This is an authentic OEM replacement drawer track for the upper rack of your dishwasher. Also known as a rack slider bar, it helps to support the top rack and allows it to glide in and out of your dis...

Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.

If the upper rack of your dishwasher has become difficult to roll in and out, or it keeps getting jammed, you may need to replace one or more wheels. Over time the plastic can become brittle, or deter...

Sold individually. Used with the heating element.

The retainer clip is used to hold the access panel on your dishwasher in place. It is a genuine OEM part that is black in color and sold individually. The only tool required to complete the repair is ...

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This genuine OEM filter is found under the lower spray arm in the bottom of your dishwasher. It is used to trap debris and prevent it from entering the pump. If your dishes are not properly cleaned or...

If your dishwasher has started leaking, there may be an issue with the door seal. This genuine OEM replacement part measures approximately 22 inches long and 2 inches wide. The seal is made of plastic...