66513403N413 Kenmore Dishwasher - Parts

If your dishwasher door is not opening or closing properly, it may be time to install a new balance kit. This part helps to support the weight of the door as it opens and closes. You should also check...

This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

The dishwasher positioner clip is also known as a rack adjuster and is used to hold the top rack in your dishwasher in the desired position. If the rack is not staying in place, the clip may have beco...

If there is still water left in your dishwasher after it has finished running, there may be an issue with your drain pump. The pump is designed to remove water from the tub, and if that is not happeni...

Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.

The dishrack adjuster, also known as an adjuster clip, is used to change the height of the top rack in your dishwasher. If the clip has become damaged, it may not function properly, which would result...

Sold individually.

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This genuine OEM filter is found under the lower spray arm in the bottom of your dishwasher. It is used to trap debris and prevent it from entering the pump. If your dishes are not properly cleaned or...

The heater element is located in the bottom of the dishwasher. It is used to maintain the temperature of the water during the wash cycle and to dry the dishes afterwards. If your dishes are not coming...

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.