5871710591 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Kevin from Old Orchard Beach, ME
- Parts Used:
- 154106202
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
My dishwasher was leaking from and electrical connection at the heating element
There was an excellent "how to" video on the internet which also pointed me to the part I needed. I did not even remove the dishwasher as recommended. I removed the lower kick plate, removed the power connector at the leaking input, removed the bad nut and installed the new nut.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Oak Harbor, WA
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Brass Nut Cracked - Water Leaks O Floor
I removed the 2 screws that hold the dishwasher in place. Slide out the unit just far enough to access the brass nuts on the heating element. Pulled off the wire, and replaced the broken nut with the new nut. Replaced the wire, slide the unit back into place and reattached the 2 under counter screws. Done!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hermon from Brentwood, NH
- Parts Used:
- 154106202, 5300806833
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Water leaking from heater element, was split and prevented a leak tight seal
Removed front toe kick plate, removed elect.wire, Lifted heating element up replaced old gromet seal put element back through tub put new not on the element and tighetend up with One half inch deep socket ,Replaced plastic wire cover over element spade conector replaced electric wire on to element. Start machine checked r leak, replace toe kick plate.......... Done
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRUCE from DEPEW, NY
- Parts Used:
- 5300809008, 5300806833
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Mother-in Law reports leak
Laid over portable dishwasher and looked for evidence of a leak.Nothing obvious. Looked up Illustrated parts breakdown to see what could be the possible source and settled on the main seal on the water pump between the washing machine itself and the motor. Also replaced grommets on the heating element.She hasn't used it yet but am confident problem is solved.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- william from sun city, CA
- Parts Used:
- 154106202, 5300806833
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
leaking water from heating element
first I shut off power at breaker then took off bottom panel,removed old nuts had a problem with the 1 in the back had to remove a few wires to be able to reach in.Then i open door removed dishwasher rack and heater element notice that the hole was rusted out a little so I cleaned area up and used permatex silicone all the area installed the new grommets replaced the heating element put it all back together will test for leaks after silicone cures
Was this instruction helpful to you?
Thank you for voting!