5871400191 Kenmore Dishwasher - Parts

This heating element mounting nut is used in dishwashers and is used to hold the nut to prevent leaking. If your nut is damaged or you notice leaking from the dishwasher, then replacing this nut will ...

This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwashe...

Sold individually.

Sold individually.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This detergent cup repair kit comes with the cam, spring and o-ring.

This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.

This bi-metal dispenser assembly is four inches long.