110723120 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gregory from North Port, FL
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Water leaking from front door of dishwasher
Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathy from Chapel Hill, TN
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
door leaked
removed old seal, placed new seal in place. Used my fingers to push it in place. It didn't work as it still leaks. I've put vaseline on the seal and door and it helps but still leaks. The dishwasher doesn't overfill, so I still have the problem, just not as bad.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roger from Duluth, MN
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Small leak in bottom right corner of dishwaher
Took off bottom plate (2 screws) and ran unit to ensure where leak is from....it appears to be the door seal. Pulled out old seal with fingers and replaced door seal, ensuring its properly "fitted"..ran unit, no leaks, put bottom plate back on
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debra from York, PA
- Parts Used:
- WP3378134
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cap did not stay in the hole any longer.....was melted
Just screwed the new cap in. This PartSelect was AWESOME. So easy. Lighting fast shipping !!!!
Was this instruction helpful to you?
Thank you for voting!
Color didn't match updated look
First I removed the the rubber sides. Then I slide the replacement panel over the exisiting one. That's it no other tools were needed. I didn't even break a sweat.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRIAN from GOWANDA, NY
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
door seal leaked steam
It was a very simple repair. I removed the old door seal out of the track and installed the new seal.
Was this instruction helpful to you?
Thank you for voting!
Soap Lid Pin Broken
Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.
Was this instruction helpful to you?
Thank you for voting!
slow leak at motor/pump interface
Got parts breakdown online, took pump assy apart, ordered new parts, replaced bad parts, put pump assy and dishwasher back together, piece of cake, no problems.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles F. from Burnet, TX
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
water leaked through door gasket.
Lowered door and put a weight on it to keep it open. with screwdriver pried out the old gasket. It was simple. looked at the end of the replacement gasket and inserted it into the track with the small hole down. Job Complete. about three minutes total time.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ANTHONY from MANITOWOC, WI
- Parts Used:
- W10844024
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Wrench set
broke water inllet valve
disconnected the water, removed the old valve put in new valve and waah laah it worked .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rod from Dripping Springs, TX
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
front leak
pulled out the old gasket, aligned and pressed in the new gasket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Crystal from Bowman, GA
- Parts Used:
- WP3369769
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Front door panel was missing
I removed the cardboard insert, put the new front panel on and replaced the tabs. That was it!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from Carlsbad, CA
- Parts Used:
- WP3378138
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
The detergent door won't open fully
Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.
i'
I'll be calling and returnint the part.
i'
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- dwight from onaka, SD
- Parts Used:
- WP3372028
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
I broke one part trying to install
no tools necessary buy instructions would have brrn helpful
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john a from west seneca, NY
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
leaking around door
1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.
THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
Was this instruction helpful to you?
Thank you for voting!