6651574992 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gregory from North Port, FL
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Water leaking from front door of dishwasher
Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debra from York, PA
- Parts Used:
- WP3378134
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cap did not stay in the hole any longer.....was melted
Just screwed the new cap in. This PartSelect was AWESOME. So easy. Lighting fast shipping !!!!
Was this instruction helpful to you?
Thank you for voting!
Soap Lid Pin Broken
Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.
Was this instruction helpful to you?
Thank you for voting!
Color didn't match updated look
First I removed the the rubber sides. Then I slide the replacement panel over the exisiting one. That's it no other tools were needed. I didn't even break a sweat.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bennett from Fayetteville, NC
- Parts Used:
- 3369447
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
dishwasher will not work,
one screw held the switch in place and is located at the front left of the machine at the bottom access panel, the new part was exactly as the old, the wires pulled off easy and plugged in to the new with no problem, switch still makes a noise and did not fix the problem, my fault not yours. Timer is moving thru the cycle but machine does no run or water flow in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mike from Auburn, AL
- Parts Used:
- WP3369193
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
The corners of the panel were the screws hold the cover onto the appliance had broken.
When the new part arrived I had to swap over the bottom metal plate that secures the bottom of the cover and also had to swap over the decorative front plate and top edge. The part worked wonderfully the job was very easy. The only thing I forgot to check on was the color of the part. I needed white and I ordered black, but that also was no big deal as the covers from the old part was white and covered it up. I will be using Partselect in the future and would recommend them to friends.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRIAN from GOWANDA, NY
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
door seal leaked steam
It was a very simple repair. I removed the old door seal out of the track and installed the new seal.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Lexington, NC
- Parts Used:
- 3373360
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken upper rack clips
Removed the rack and the broken clips. Replaced the clips. Reinstalled the rack.
Can't tell you how pleased I am with the service you have provided.
Can't tell you how pleased I am with the service you have provided.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rod from Dripping Springs, TX
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
front leak
pulled out the old gasket, aligned and pressed in the new gasket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Crystal from Bowman, GA
- Parts Used:
- WP3369769
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Front door panel was missing
I removed the cardboard insert, put the new front panel on and replaced the tabs. That was it!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles F. from Burnet, TX
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
water leaked through door gasket.
Lowered door and put a weight on it to keep it open. with screwdriver pried out the old gasket. It was simple. looked at the end of the replacement gasket and inserted it into the track with the small hole down. Job Complete. about three minutes total time.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from Carlsbad, CA
- Parts Used:
- WP3378138
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
The detergent door won't open fully
Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.
i'
I'll be calling and returnint the part.
i'
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john a from west seneca, NY
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
leaking around door
1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.
THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nate from Fort Worth, TX
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water Seeping From Under/Around The Door
I opened the door and pulled the gasket from around the dishwasher. The gasket does not have any adhesive around it, so it pulled free almost immediately. The new gasket was pressed into place around the door and I was done. It couldn't have been any easier. I suspected it was the gasket when I saw pinched portions that did not return to the original shape and there were no visible cracks in the machine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathryn from Carol Stream, IL
- Parts Used:
- WPW10348409
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Screws on the door of the dishwasher were very loose.
Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!
Was this instruction helpful to you?
Thank you for voting!