58715232900 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gary from NEW KENSINGTN, PA
- Parts Used:
- 5304506525
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Replace filter in dishwasher
Watching a YouTube video that was attached to an email, I was able to install my new dishwasher filter in no time without any tools. Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carol from Miami, FL
- Parts Used:
- 5304507405
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Broken wheel on upper rack.
Replacement was simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kim from King City, MO
- Parts Used:
- A00099902
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
latch was broken
took out the screws holding the inside of the door on, pulled out the old switch, plugged in the new and put the screws back in done in 20 min.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from SEATTLE, WA
- Parts Used:
- 5304535382, 5304535768
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
lower dish rack was rusted out in places, silverware basket was falling apart
replaced the wheels on the new rack with wheels from my old rusty rack, placed the silverware basket in the new rack and rolled it in
Took < 5 minutes
Took < 5 minutes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dante from SOUTHOLD, NY
- Parts Used:
- 809006501
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Broken BOTTOM door gasket
1-2-3. Finished ! I had watched your video on how to !
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rose from Summerville, SC
- Parts Used:
- 154388801
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The rinse cap was mutilated, the rinse agent leaked.
Simply unscrewed the old. Replaced with the new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary A. from Akeley, MN
- Parts Used:
- 154701001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Leakage under door.
Followed instructions with parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jan from DENVER, CO
- Parts Used:
- 154388801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rinse aid cap fell off during the drying session and was warped as a result.
I just had to buy a new cap and screw it in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from PENN YAN, NY
- Parts Used:
- 5304512731
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Wouldn't run!!
Repair man gave indication that it would cost 2-300 dollars to fix!! We looked into new and found your site. Decided to try it!! Glad we did!! Easy fix for less than $200 and it works!!! Thank you!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harold from SHELOCTA, PA
- Parts Used:
- 809006501
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Leaking water
followed online video provided and it was a snap
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from PONCA CITY, OK
- Parts Used:
- 140229954072, 5304535768
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
racks old, worn, rusting
took out the old racks - put in the new racks... only had to move one part from old to new on upper rack assembly.. easy! and quick -- I'm over 60 - female - arthritis in my hands -- and I could do... so can you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Victor from APPLE VALLEY, MN
- Parts Used:
- 140229954072, 5304535768
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
the tines on the dishwasher racks were loosing material so dishes were getting scratched.
I WATCHED THE VIDEOS. EXCELLENT HELP.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Shelley from LACONA, NY
- Parts Used:
- 5304523457
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
Dishwasher hose had hole in it. It was 23 years old.
After getting a totally incorrect length of hose from partselect.com . Went to local hardware store and bought hose for $3.00 vs $20.99 + $10 shipping!
Partselect sent replacement hose of 24 1/4” vs the original hose of 27”. Good luck getting any response from them once they have your money!
Partselect sent replacement hose of 24 1/4” vs the original hose of 27”. Good luck getting any response from them once they have your money!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Felipe from Poughkeepsie, NY
- Parts Used:
- 154574401
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Cap would not close
At first I wasn't sure; I thought I had to buy the inner panel of the door. Considering that I have to minimize expenses I made it a point to tackle the problem myself. I unscrewed the outter panel off the dishwasher door and located the dispenser from inside of the inner door panel.
I unplugged the old dispenser,which was damaged, unscrewed it from the panel and removed it. I cleaned any and all debris, dirt and soap scum it had accumilated over the short years we've owned it.
Finally; after I prepared the new dispenser for installation, I placed it in position screwed it in and plugged it in, which was slightly tricky because it is pretty snug against the inside door panel. Once installed, I got my older son, 15, to help me screw in the outside panel of the door, and as he held it I screwed it on the the inside panel.
I tested it with no dishes inside by pouring just a little detergent in the new dispenser, starting the dishwasher and I stuck around in case there were any leaks or any other possible disaster that could occur.
This was exactly one week ago and all is still well. By the way, the person who took my order, I believe her name was Joann, was great. She talked to me making certain I had the right part, which I was unsure of since the diagram on your site was not quite clear. On top of that; I didn't pay for overnight service, yet my part was at my door the next day. I was amazed at the quick service and delivery. Thanks Joann!!!
Felipe,
Poughkeepsie, NY
I unplugged the old dispenser,which was damaged, unscrewed it from the panel and removed it. I cleaned any and all debris, dirt and soap scum it had accumilated over the short years we've owned it.
Finally; after I prepared the new dispenser for installation, I placed it in position screwed it in and plugged it in, which was slightly tricky because it is pretty snug against the inside door panel. Once installed, I got my older son, 15, to help me screw in the outside panel of the door, and as he held it I screwed it on the the inside panel.
I tested it with no dishes inside by pouring just a little detergent in the new dispenser, starting the dishwasher and I stuck around in case there were any leaks or any other possible disaster that could occur.
This was exactly one week ago and all is still well. By the way, the person who took my order, I believe her name was Joann, was great. She talked to me making certain I had the right part, which I was unsure of since the diagram on your site was not quite clear. On top of that; I didn't pay for overnight service, yet my part was at my door the next day. I was amazed at the quick service and delivery. Thanks Joann!!!
Felipe,
Poughkeepsie, NY
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- GEORGE from PORTSMOUTH, VA
- Parts Used:
- 140229954072, 5304535768
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
My old racks were rusting from the top of the tines.
I thought these were OE racks they are not. They did do the job. However, I like OE parts the difference is exactly where the fold over rack on top rack goes the tines were not there to clip on it into there was a larger gap. So it was almost the same except the most important area. Same for the cone that clips in the center of the top rack. It is not as tight a fit front to back as it should be so it moves around more. I was concerned that the jet of water from top would miss the cone but it seems to be ok. So far so good. The racks did the job dishwasher is still cleaning dishes. But aftermarket parts are almost the same just not quite the same.
Was this instruction helpful to you?
Thank you for voting!