66513723K600 Kenmore Dishwasher - Parts

New Black Single Metal Access Panel Replacement Kit. Replaces old two part toe kick plates. Reuse insulation off old panel or see Recommended Parts.

This part is the door actuator for your dishwasher. It is made of black plastic and is approximately 3 inches long and 3 inches wide at its widest point. The door actuator is found in the control pane...

Shield

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

This track attaches to the inside of the tub for the upper rack to glide in and out.

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

16ml

This part is used to cover the chopper blades.

This clamp helps to prevent leaking by holding the end of water hose in place.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

This part forces the water from the pump to the sump area for discharge.

This mount assembly attaches on either side of the inner cabinet wall for the upper rack. It glides over and under the the slide track.