66513552K700 Kenmore Dishwasher - Parts

This part is used to cover the chopper blades.

This clamp helps to prevent leaking by holding the end of water hose in place.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

This part holds the spray arm feed tube up.

This part forces the water from the pump to the sump area for discharge.

This mount assembly attaches on either side of the inner cabinet wall for the upper rack. It glides over and under the the slide track.

This electronic control board is responsible for coordinating all major dishwasher operations by interpreting input from sensors and the control panel. It regulates water flow, cycle timing, and dryin...

This part is a replacement screw for your dishwasher. It is made of metal and is approximately ¾ inch long. It is a hex-head screw and is sold individually. It is used to hold the dispenser bracket in...

This manufacturer-approved door vent gasket (part number WP8269259) is for dishwashers. Door vent gasket WP8269259 forms a seal between the door panel and the vent duct. Shut off the house circuit bre...

Water that fills your dishwasher lifts the float. When it reaches a certain level, the float triggers this float switch to shut off, thereby shutting off the flow of water into the dishwasher.